Subscribe to newsletter

News   Industrial Maid LLC: Plastic vs Steel   Dec 8, 2004 By Jeff Zvolanek, Industrial Engineer – Industrial Maid LLC Industrial Maid has developed a line of air filtration products that utilizes recycled high density polyethylene plastic. The outer cabinet is fabricated from plastic rather than steel. The use of plastic versus steel offers several key benefits including the following: lower cost than steel resists denting and scratching dampens the noise of the motor/blower plastic is 38% the weight of steel (lighter finished product) manufacturing polyethylene requires only a fraction of the energy required to produce steel from iron ore less waste stream for compliance to ISO 14,001 purchasing standards (less water, air and soil contamination in the manufacturing process i.e. no painting, grinding, washing & welding involved on the exterior cabinet) very resistant to caustic materials that may break down steel and its coatings may be recycled up to 10 times during its organic lifecycle The polyethylene plastic does not offer the same strength characteristics of steel, but that is not a critical factor with the air filtration cabinets. Polyethylene does meet all NFPA fire codes for an exposed material.

Industrial Maid 721 Westgate Blvd Lincoln, NE 68528   Air Filtration Unit Cabinets Molded From Plastic Milk Jugs   Other news from Industrial Maid

Summary - the use of plastic in the manufacturing process for air filtration products will help the user in the following ways:

The bulk of the preceding data was collected by University of Nebraska Partners in Pollution Prevention intern Alex Pesak. Alex, a senior mechanical engineering student, worked during the summer of 2004 studying the feasibility of using recycled polyethylene plastic as an alternative to carbon steel. He also looked at the environmental benefits of plastic versus steel.

Note: disclaimer below

DISCLAIMER
The contents of this report are offered as guidance. The University of Nebraska and all technical sources referenced in this report do not (a) make any warranty or representation, expressed or implied, with respect to the accuracy, completeness, or usefulness of the information contained in this report, or that the use of any information, apparatus, method, or process disclosed in this report may not infringe on privately owned rights, (b) assume any liabilities with respect to the use of, or for damages resulting from the use of, any information, apparatus, method, or process disclosed in the report. This report does not reflect the official views or policy of the above-mentioned institutions. Mention of trade names or commercial products does not constitute endorsement or recommendation of use.

Home | Terms of Use | Privacy Statement | Link to AECinfo
AECinfo is a member of Docu Group, the world's largest building products information network.

Back to normal layout