| BHMA TYPE E19231
FUNCTION:
Designed for use with Adams Rite 1847 or 4035
deadlocks and latches, these surface mounted pulls allow a sliding glass door to be
"keyed-in" with other types of doors which have key-in-knob or mortise cylinder
locks.
4025 has mounting holes spaced to allow clearance
around 1847 lock mechanism for long thru-the-stile mounting screws.
4024 is smaller and symmetrical, designed for
mounting on door pull or other trim plate. (Can be mounted directly on stile where lock
mechanism is mounted on inside surface of stile rather than mortised.)
OPTIONS:
CYLINDER MAKE: Pulls available from stock with
Adams Rite, Schlage, or Weiser keyway cylinder. For 4025 with special keying of these
makes or for any of the other makes listed on next page:
FURNISH PROPERLY KEYED CYLINDER TO ADAMS RITE FOR
MODIFICATION AND/OR INSTALLATION IN PULL
| TRIM FINISH Zinc alloy housing. Ritecoat 130 finish is standard. See page SW-101
for other Ritecoat colors. Cylinders, brass. |
| CYLINDERS BOTH SIDES A pair of 4025 cylinder-pulls can be mounted opposite each other
with long machine screws as shown. Security is maintained since each side offers access to
only one screwhead. Both screws would have to be removed to operate the lock without its
key. Specify 4025 CYL X CYL. set. |
©1971, 1975, 1976 by |
