Halogen inserts allow the use of halogen lamps in place of or in combination with festoon lamps in any Clikstrip. Order Cilkstrip units with socket spacings sized for halogen inserts or make simple adjustments on site. Inserts HI-F, HI-FB, HI-FS and HI-FSB are UL Listed for use with enclosed halogen lamps or with cowl attachments in UL Listed Clikstrip. HI-BLC and HI-BLF are UL Listed for use in UL Listed Clikstrip.

HI-F	Multi-directional insert size for use in standard festoon lamp spacing, for use with MR-11 lamps (35 w max) - white.
HI-FB	Multi-directional insert size for use in standard festoon lamp spacing, for use with MR-11 lamps (35 w max) - black.
HI-FS	Multi-directional insert size for use in standard festoon lamp spacing, for use with MR-16 lamps (35 w max) - white.
HI-FSB	Multi-directional insert sized for use in standard festoon lamp spacing, for use with MR-16 lamps (35 w max) - black.
HI-T	Pivoting insert for use with TAL lamps (35w max).
HI-BLC	Fixed position insert with reflector and clear protective cover glass for use with bare G4 base halogen or xenon lamps (10w max).
HI-BLF	Fixed position insert with reflector and frosted protective cover glass for use with bare G4 base halogen or xenon lamps (10w max).
HI-B	Fixed position low-profile insert with reflector for use with bare G4 base halogen or xenon lamps (20w max).

CLIKSTRIP COVER

Glass covers for Clikstrip are ideal to protect festoon lamps and provide a shield against lamp contact. These 1-3/16" O.D. 1/8" thick half tubes can be used with Clikstrip with lamps of 5 watts or less. Mounting clips are installed underneath Clikstrip and are secured with a single screw. A minimum of two mounting clips per glass piece is required. 5W festoon lamp maximum - tape mounted strip only.

COWLS, LENSES, LOUVERS

Spun aluminum lamp cowls with black finish fit over MR-11 and MR-16 lamps. Used alone, the cowls greatly reduce side glare and add a finished look to exposed lamps. Add lenses and louvers for control and lighting effects. A spun aluminum louver and lens holder is available for MR-16 lamps. This holder holds louvers and lenses at the rim of the MR-16 lamp without blocking the light emitted from the rear of the lamp's reflector. Either a cowl or a louver and lens must be used to hold lenses and louvers in place.