MILLS PARTITIONS
TECHNICAL DATA

Restroom Partition
Maintenance Instructions
Type of Cleaning Cleansing Agent* Method of Application** Effect on Finish
Routine Cleaning Soap, ammonia, or detergent and water Sponge or cloth, then rinse with clear water and wipe dry Satisfactory for use on all finishes
Stubborn Spots and Stains, Baked-on Spatter, and other light discolorations Revere Ware Cleaner, Twinkle, Cameo Stainless Steel Cleaner

Goddard's Stainless Steel Care, Revere Ware Stainless Steel Cleaner, Soft-Scrub

Household cleaners such as Old Dutch, Bon Ami, Ajax, Comet, Zud

 Apply with damp sponge or cloth, rub with damp cloth.

Apply with damp sponge or cloth.

Rub with damp cloth. May contain chlorine bleaches. Rinse thoroughly after use.

 Satisfactory for use on all finishes if rubbing is light. Use in direction of polished lines.

Satisfactory for use on all finishes if rubbing is light. Use in direction of polished lines.

Always use in direction of polished lines. May scratch or dull highly polished finishes.
Burnt-on Foods and Grease, Fatty Acids, Milkstone (where swabbing or rubbing is not practical) East-Off Oven Cleaner Apply generous coating. Allow to stand for 10 to 15 minutes. Rinse thoroughly. Repeated applications may be necessary. Excellent removal. Satisfactory for use on all finishes. Use in direction of polished lines.
Hard Water Spots and Scale Vinegar Swab or wipe with cloth. Rinse with water and dry. Satisfactory for all finishes.

** Use of brand names is intended only to indicate a type of cleaner. This does not constitute an endorsement. Nor does the omission of any brand name cleaner imply its inadequacy. Many products named are regional in distribution, and can be found in local supermarkets, department and hardware stores, or through your cleaning service.

** It is emphasized that all products should be used in strict accordance with package instructions.

The Mills Company reserves the right to make changes in design, material, and documentation without formal notice and without incurring obligation. Verify all rough-in dimensions prior to installation.

Consult local and national codes: conformity and compliance to local and national codes is the responsibility of the installer.