Semi-Circular Washfountain Rough-In Dimensions

Rough-In Notes:

1. All pipes and fittings not furnished by Bradley are shown in broken lines.
2. Supply lines for one to two washfountains should be 1"; for three washfountains 1-1/4"; for more than three wash fountains, pipe sizes should be increased proportionately.
3. Overhead supplies must be reduced to 1/2" copper tube to pass through support tube.
4. Check valve inlets are 1/2" IPS.
5. Dimensions shown in parentheses are millimeters.
6. See reverse side for anchoring pedestal to wall and floor.

Installing Traps

When installing trap with a coupling and nipple, see dimension D in the charts below.
If trap is installed tight to bottom of bowl, dimensions D depends on design of trap.