architecture - engineering - construction
AECinfo.com
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share
  Bradley Fixtures Corp.   Bradley Washfountains  

Bradley Washfountains - Page 32

   

Bradley Washfountains

PLUMBING FIXTURES
TECHNICAL DATA

Classic Washfountains

Corner w/9" Deep Bowl


Corner Washfountain Rough-In Dimensions

Rough-In Notes:

  1. All pipes and fittings not furnished by Bradley are shown in broken lines.
  2. Supply lines for one to two washfountains should be 1"; for three washfountains 1-1/4"; for more than three washfountains, pipe sizes should be increased proportionately.
  3. Overhead supplies must be reduced to 1/2" copper tube to pass through support tube.
  4. Check valve inlets are 1/2" IPS.
  5. Dimensions shown in parentheses are millimeters.

Coupling and Nipple Hookups:

Use the chart to the right when hookup is made with a coupling and nipple. When trap is installed tight to bottom of bowl, dimension B depends on design of trap. (2" drain through wall must not interfere with diagonal frame member on pedestal).

Bradley Corporation reserves the right to make changes in design and material without formal notice and without incurring obligation. Verify all rough-in dimensions prior to installation.



Request for Information / Request a Catalog from Bradley Fixtures Corp.
 
 
 
To request more information from Bradley Fixtures Corp., please complete the form below.
 
*Name:    
*Email:    
Company:    
*Type:    
Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
Please add me to the mailing list for the free monthly e-Newsletter AECnews.