| BRADSTONE MASONRY BLOCK
WALLING Bradstone Masonry Block
Walling simplifies the construction of fully random rubble walling by suing only two block
components. `T’-shaped blocks are moulded to represent separate stones, with false
mortar joints for subsequent pointing. They interlock with each other and with a smaller
infill block to create an authentic random rubble walling pattern, with no apparent
coursing. Masonry Block Walling is available in five shades based on the appearance of
regional stone.
General
Essentially a modular system, Masonry Block
Walling composite block and a 3" high infill block component, used to provide
alignment between the upward-and downward-facing `stems’ of main blocks and as infill
between them and End Blocks, Quoins, cills, etc. Both block units are 18" in length
and all blocks are frogged. By using a wide range of different moulds, the Walling Blocks
offer sufficient modular and textural variety to avoid obvious repetition, with careful
onsite selection essential. There is a choice of three corner details, as described above.
 |
 |
 |
| Walling "T"
Block |
Infill Block |
Dressed End 9" x
13" |
 |
 |
 |
| Masonry End 9" x
13" |
Masonry End 9" x
4" |
Plain "L"
Quoin |
Dimensions
| Block Type |
Course Height (mm) |
Length (mm) |
| |
4" |
9" |
13" |
18" |
| Walling Blocks |
9" |
|
|
|
• |
| Infill Blocks |
3" |
|
|
|
• |
| Masonry Ends |
9" |
• |
|
• |
|
| Dressed Ends |
9" |
|
|
• |
|
All dimensions are
nominal
Heights and lengths of blocks are shown in
this chart. All blocks are supplied 90mm on bed depth.
Appearance
| Standard
Shades Available |
| Cotswold |
Weathered Cotswold |
| North Cerney |
Weathered York |
| |
Kingston Gray |
Shades
The range is available in five shades based on regional
stone.
Other shades available to order |
