Carlisle Single Ply Systems (Carlisle SynTec Incorporated)

METAL RETROFIT

Typical Re-roofing Application

Sure-Seal 45-mil Reinforced EPDM Membrane
Carlisle HP Purlin Fasteners
HP Fasteners
Sure-Seal Insulation
Acceptable Insulation
Existing Metal Roof

Metal Retrofit

Carlisle's Metal Retrofit System can be installed over existing standing seam, flat seam or corrugated metal. These roofing options provide a lightweight solution to leaking metal roofs.

		THREE SYSTEM OPTIONS EXIST
		NON-PENETRATING FLEECEBACK	FULLY ADHERED EPDM	MERCHANICALLY FASTENED REINFORCED EPDM
		FLUTES OF EXISTING METAL ROOF ARE FILLED WITH AN ACCEPTABLE INSULATION
1	HOW IS EPS ATTACHED?	INSULATION IS SET INTO FAST ADHESIVE	INSULATION IS LOOSE-LAID INTO FLUTES	INSULATION IS LOOS-LAID INTO FLUTES
SURE-SEAL INSULATION IS THEN LAID OVER EXISTING ROOF
2	INSULATION ATTACHMENT METHOD	SET INTO FAST ADHESIVE	HP OR HP-X FASTENERS SECURE INSULATION TO EXISTING METAL	INSULATION IS MECHANICALLY FASTENED INTO EXISTING METAL WITH HP FASTENERS
4	MEMBRANE ATTACHMENT METOD	FLEECEBACK MEMBRANE IS SET INTO FAST ADHESIVE AND SPLICES ARE COMPLETED	BONDING ADHESIVE IS UTILIZED TO ADHERE EPDM MEMBRANE TO THE INSULATION	HP PURLINS ARE USED TO FASTEN REINFORCED EPDM MEMBRANE INTO EXISTING PURLINS

Note: For Membrane Specifications, see page 11

For current Code Approvals and Warranties, visit Carlisle's website, or contact the Design Analyst located in your regional office. (See page 12).

YOUR SINGLE-PLY SOLUTION_™

(800) 4-SYNTEC• www.carlisle-syntec.com

Carlisle Single Ply Systems - Page 9