| INSTALLATION SURE-DRAIN can be attached to the CCW waterproofing with double face
tape, construction adhesives, or most approved methods used for adhering protection board.
Discuss materials compatibility with CARLISLE representative before using adhesives.
SURE-DRAIN-H and HD may be loosely laid on horizontal substrates directly over Carlisle
waterproofing membranes. Temporary ballasting is required if high winds are expected prior
to overburden placement.
Make all overlaps of core and fabric edges in a shingle
fashion so that water flows in the same direction as the overlap. If necessary, use tape
or adhesive to keep fabric in place prior to backfilling. To attach the end of a roll of
drain to the end of the next, peel back filter fabric and overlap two rows of dimples.
Press to interlock the panels, then pull the fabric back over the joint, overlapping both
in the direction of expected water flow.
All terminating edges of the drainage composite should have
extra fabric tucked behind core to seal the edge and prevent soil from entering the core.
VERTICAL WALL: Place the first panel of
SURE-DRAIN-V at the bottom of the wall. Install with the flange edge up, the geotextile
filter fabric out, and the polymeric film against the wall. Where a drain pipe will
be used , position the lower end of core horizontally to allow drainage pipe to rest on
core. Pull fabric around pipe and tuck under core. If weep holes or discharge pipes in the
wall are used instead of a drain pipe, cut 1/2" holes in the flat back of the core at
these locations; do not cut fabric. Place the lower edge of next panel (edge without a
flange) overlapping the flange of the previously installed panel. Overlap the fabric in
the direction of the water flow.
HORIZONTAL DECKS: Install SURE-DRAIN or HD with
the geotextile fabric side up. The flange edge of the core should be placed up slope, away
from the drains, so that subsequent layers will overlap in a shingle fashion to shed
water. Cut core and fabric to fit tightly around floor drains. Ensure that paths to
weep holes on two stage drains will remain open. Concrete , sand or mortar may be placed
directly on SURE-DRAIN-H or HD .Use care to prevent puncture or tearing of the geotextile
filter fabric.
LIMITED WARRANTY
CARLISLE COATINGS AND WATERPROOFING INCORPORATED (CARLISLE)
warrants this product to be free of defects in workmanship and materials at the time of
shipment from our factory. If any CARLISLE materials prove to contain manufacturing
defects that substantially affect their performance, CARLISLE will, at its option, replace
the material or refund its purchase price.
This limited warranty is the only warranty extended by
CARLISLE with respect to its materials. There are no other warranties, including the
implied warranties of merchantability and fitness for a particular purpose. CARLISLE
specifically disclaims liability for any incidental, consequential, or other damages,
including but not limited to, loss of profits or damages to a structure or its contents,
arising under any theory of law whatsoever.
The dollar value of CARLISLE'S liability and buyer's remedy
under this limited warranty shall not exceed the purchase price of the CARLISLE material
in question.
| Carlisle is a
trademark of Carlisle Corporation ©1998 Carlisle
Corporation
SURE-DRAIN 11/98 pb |
 |
Carlisle Coatings
& Waterproofing Incorporated Subsidiary of Carlisle Corporation P.O. Box 1600, Sapulpa, OK 74067-1600.
Telephone: 1-800-338-8701
Website:www.carlisle-ccw.com |
|
