CHEMST0NE PRODUCTS

LIQUID CONCENTRATE

FOR SHRINK CONTROL - WATERPROOFING - HIGH BOND STRENGTH

MASONRY

BERYLEX Liquid Concentrate increases both early and ultimate strengths, gives greater hardness, bonding, salt and acid resistance and- water-proofing. Decreases efflorescence, water bleeding, shrinkage, dusting, and flash setting.

•  Has more slipperiness for easier pumping
•  Retains moisture in the mass
•  Imparts an even cure throughout the slab
•  Faster stripping

ADMIXTURE

1.  Measure out 8 to12 ounces, as required, BERYLEX Liquid Concentrate per each 94 lbs. sack of common Portland Cement.
2.  Pour this into the gauging water that is to be used for the batch mix.
3.  NOTE: Always blend the BERYLEX Liquid Concentrate into the mix prior to adding any additional water.
4.  This is important to the BERYLEX Liquid Concentrate function.

IF DELIVERY IS BY BATCH TRUCK DELIVERY:

1.  Always specify a low slump 2" to 3" from batch plant.
2.  Measure out desired amount of BERYLEX Liquid Concentrate per each sack of cement.
3.  Pour this into an empty 5 gallon container. Fill up half way and stir.
4.  Stop revving truck hopper.
5.  Dump this solution into hopper and rev again for 5 to 6 minutes, then pour out.
6.  BERYLEX Liquid Concentrate mix is easier for the finisher to work with, due to the tact that it is a richer mix. It is easier to push, easier to level out and much easier to trowel.
7.  BERYLEX Liquid Concentrate can be added at the batch plant by dumping it into hopper after dry mix goes into drum. It is important to cut back on water by at least 12%, when adding water to the batch.
8.  When working with portable mixer, dilute 1 quart of BERYLEX Liquid Concentrate to 5 gallons or water. Stir and use only this solution for the wet mix (no other water).
9.  Do not use any other admixtures, only common Portland Cement.
10.  NOTE: Always wash off tools and equipment when the job is completed. If a BERYLEX mix dries on metal tools, they are no longer usable. The cement mix is there to stay.
11.  Conforms to: ASTM - C - 494 - TYPE A.



PLEASE NOTE:

All chemicals have a certain amount of health hazard conditions involved and should be used accordingly. While we believe that the data contained herein are factual and the opinions expressed are those of qualified experts regarding the results of the tests conducted, the data are not to be taken as a warranty or representation for which we assume legal responsibility. They are offered solely for your consideration and
verification. Any use of this data and information must be determined by the user to be in accordance with applicable Federal, State, OSHA and Local Laws and Regulators. Material Safety Data Sheets (M.S.D.S.) are available upon request and required on some large projects. Check out the necessary requirements in your local area.

Is used to make BETTER concrete - Not to replace cement BERYLEX cannot correct human errors or man failures.