HIGH CAPACITY SUBMERSIBLE TURBINE PUMP SPECIFICATIONS

• The entire pumping assembly shall have UL listing and shall meet all requirements of UL Standard UL79.
• The pump discharge head and manifold assembly shall be manufactured from ASTM A48 Class 30 grey iron.
• The pump shall be available in 3 and 5 hp sizes and shall be manufactured to the proper length as determined by the tank diameter, type of tank, and bury depth.
• The pump motor shall have a thermal overcurrent overload protector with automatic reset.
• The pump motor shall be three phase in various voltage ratings.
• The entire pump assembly shall be tested as an integral unit to assure conformity to design specifications.
• The pumping unit shall not incorporate any flexible diaphragms and all sealing shall be accomplished with "O" rings, special elastomers, or UL recognized fiber gaskets.
• The pump shall have an intake screen with openings no greater than 3/32 inch.
• The pump shall be manufactured by FE Petro, Inc., McFarland, WI.

INSTALLATION AND MAINTENANCE

• The pump shall have a five-wire field connection and shall incorporate a factory connected grounding wire.
• The pump unit shall have a fully extractable head in order to permit removal of the pump motor assembly without disturbing the discharge piping or the electrical wiring.
• The product in the pipelines shall be held in place by two line check valves that are an integral part of the pump.
• During the removal of the extractable portion of the pump, product contained in the discharge manifold of the pump shall drain automatically into the storage tank.
• Two lifting eyes shall be provided to facilitate removal of the extractable portion of the pump.

OPERATION

• The pump shall have an air / vapor elimination system that returns air or vapors to the underground storage tank through a tube discharging near the top of the pump motor assembly.
• The pump unit shall contain two built-in expansion relief valves that relieve pressure near pumping pressure but below 50 psi.
• The pump motor shall utilize the product being pumped for lubrication of the motor bearings and for cooling the stator, and this fluid shall discharge into the underground storage tank at the top of the motor.