FLEX	TRAY®
	FLEXTRAYIS...

---

UL CLASSIFICATION

FLEXTRAY meets all applicable UL standard requirements regarding tray use as an equipment ground conductor. The following FLEXTRAY sizes, along with a BOLTED splice connection,  are UL approved:

FT1.5x12x10
FT2x8x10
FT2x12x10
FT2x16x10
FT2x20x10

*Note – Equipment ground suitability is based on tray cross sectional area. Therefore, when performing field fabrication to create fittings, bonding jumpers must be used to establish tray continuity.

 

CSA APPROVED
(Canadian Standards Association)

FLEXTRAY is an approved cable management system for supporting communications and optical fiber cables. FLEXTRAY complies with T.I.L. No. J-26 prepared by CSA, and was formally approved by the subcommittee on CSA Standard C22.2 No. 126.

 

NEMA
(National Electrical Manufacturers Association)

FLEXTRAY has been tested per NEMA VE1 section 4.

 

MADE IN THE U.S.A.

GS Metals Corp., located in Pinckneyville, Illinois.

 

SAFE...
The "T" weld design allows easy side loading of cable without damaging cable or hands.

 

ECONOMICAL... With FLEXTRAY, just a few parts are needed to complete an entire cable support application.

 

 

IT'SSIMPLECABLEMANAGEMENT™