CREATING DROP-OUTS
Easily fabricated in the field, or choose our new Drop-Out fitting shown below.

To form Drop-Outs, use a spare piece the same width as main rule.

Bend the spare length to the desired radius. Connect the Drop-Out to the horizontal run with two sets of Top and Bottom Washers, nuts and bolts.

Finished two-piece Drop-Out.

Always use bolt cutters with offset blades when cutting FLEXTRAY

Drop-Outs created from a single FLEXTRAY section.

Drop-Out Fitting
This Drop-Out fitting maintains bend radius of wire. Two cotter pins included.

Catalog No. — 4" DROP-OUT 6" DROP-OUT

Simply install with two cotter pins on each side.

IT'SSIMPLECABLEMANAGEMENT™