|
|
Hastings Industries Inc.
Heating Systems
Heating Systems - Page 12
Heating Systems
All Models
Standard Equipment & Optional Items
Description |
Model |
||
| IHF | IMU | IHV | |
Blower section with variable drive (thru 10
H.P.
|
Std. Std. Std. |
Std. Std. Std. |
Std. Std. Std. |
Natural (6" to 14") or propane
(11" to 14") gas duct furnace(s). Available with aluminized steel, type 409,
stainless or 321 stainless steel heat exchanger(s).
|
Std. (see note) Opt. Std. NA NA |
Std. (See note) Opt. Std. Std. NA |
Std. (see note) Opt. Std. NA Std. |
| Power venter and adapter. | Opt. | Opt. | Opt. |
| Factory assembly and wiring. | Std. | Std. | Std. |
| Blower "on-off-auto" switch. | Std. | NA | NA |
| Thermostat (on-off). | Std. | NA | Std. |
| Remote control station with operating switches and indicating lights. | Opt. | Opt. | Opt. |
| Fan time delay relay. | Std. | NA | NA |
| Filters - 2" throw-away, cleanable or extended surface | Opt. | Opt. | Opt. |
| Fresh air intake hood with birdscreen | Opt. | Opt. | Opt. |
| Fresh air shut-off damper with 2 position motor, linkage and end switch. | NA | Opt. | Opt. |
| Mixing dampers wit either 2 position motor or modulating motor & temperature controller/ potentiometer. | Opt. | NA | Opt. |
| Discharge louver assembly (remote mounting required with Select ra MS-1 and MS-3). | Opt. | Opt. | Opt. |
| Vibration isolators (rubber-in-sheer or spring vibration isolation for fan motor and fan(s). (****) | Opt. | Opt. | Opt. |
| Selectra MS-1 electronic modulation make-up air package with remote temperature selector dail in place of modulating gas valve. | NA | Opt. | NA |
| electra MS-2 electronic modulation space heating package added to basic system. Modulating thermostat replaces on-off thermostat. | Opt. | NA | NA |
| Selectra MS-3 electronic package in place of modulating valve and by-pass valve manifold. Make-up air portion same as MS-1; space heat is two position. | NA | NA | Opt. |
| Selectra MS-5 electronic package for interface to customer control center (20-4MA/0-10 VDC Signal) (****) | Opt. | Opt. | Opt. |
| Low outlet temperature shut-off. | Opt. | Opt. | Opt. |
| Day-Night operation. | Opt. | Opt. | Opt. |
| Blocked intake switch and signal light. | Opt. | Opt. | Opt. |
| Step down transformer. | Std. | Std. | Std. |
| Fused disconnect switch | Opt. | Opt. | Opt. |
| Two speed motor - 1800/1200 or 1800/900 RPM.(***) | Opt. | Opt. | Opt. |
| High efficiency motor. | Opt. | Opt. | Opt. |
| High gas pressure regular - 1/2 PSIG & over. | Opt. | Opt. | Opt. |
| Hastings/Varicool direct - indirect evaporative cooling section. (**) | Opt. | Opt. | Opt. |
(*) Not available with propane models. Std. = Standard Opt. = Optional
(***) Depending on temperature rise. Not available on all units.
Note: All "B" model units have aluminized heat exchangers on second bank or downstream furnaces. One year warranty applies. Optional 409 or 321 stainless steel heat exchangers may be substituted for aluminized heat exchangers on second bank furnaces. Five year warranty then applies for units with first and second bank 409 ss heat exchangers or ten year warranty for 321 ss exchangers.
(**) Transition from EC or Varicool units runs to both openings at rear of MB blowers.
(****) Each furnace utilizes signal conditioner for interface. Internal isolation not available on MB-218.