Homepage  
Search
find:
search for:
   
 
Site Navigation
News / Publications
Jobs
Service
   Add this page to Google Bookmarks
   Add this page to Mister Wong
   Add this page to del.icio.us
 
   Hastings Industries Inc.  Oil Heaters  

Oil Heaters - Page 3

 

 

 

OIL PIPING

NOTE : Customer must specify : 1) Type of oil feed system, 2) PSIG at Unit Heater (if pressure system); 3) Vertical distance from top of tank to Unit Heater (if gravity system)  Pressure system must be used if gravity system "head" or suction system "lift" cannot overcome piping resistance.

HEATER MANIFOLD ARRANGEMENTS

Determine correct heater manifold arrangement and required factory options after type of oil feed system is decided. Manifold items are shipped loose field installation,. All piping and lifting by others.

Engineers Specifications

Furnish and install the following oil-fired unit heaters as manufactured by Hastings Industries.

Item Model No. Btuh Output Volts/Cycle/Phase

A. General : Unit(s) shall be factory assembled and wired complete with burner, propeller fan and motor assembly, casting, controls and safety devices. Wiring external to the unit  shall be done by the installer.

Unit(s) shall be 80 percent efficient at full-rated operating condition as measured by flue-gas temperature and CO2 content prior to being exhausted.

B. Control : Main power shall be 120/60/1; control voltage shall be 24 volt. Electric spark ignition shall be provided.

C. Casing shall be (cold-rolled steel with enamel finish) (aluminum) complete with horizontal air discharge louvers.

D. Burner shall be of the high pressure, oil-atomizing type with mechanically forced draft.

E. Heat Exchanger ; Model UFO-10 shall have pyrolite lined mid steel firing chamber and secondary section of vertical aluminized steel tubes. Models UFO-25 and 50 shall have two-pass 16 gauge primary heating chamber and single pass gauge mild steel secondary section.

F. Fan and Fan Motor : Fan(S)  shall be propeller type with aluminum blades fastened to a steel hub. Fan(s) shall be direct-driven by 120 volt, totally enclosed, permanently lubricated motor(s) with internal overload protection.

In order to maintain our policy of continuous product improvement, we reserve the right to change prices, specifications, ratings or dimensions without notice or obligation.

   

Request for Information / Request a Catalog from Hastings Industries Inc.
 
 
 
To request more information from Hastings Industries Inc., please complete the form below.
 
*Name:    
*Email:    
Company:    
*Company type:    
Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
Please add me to the mailing list for the free monthly e-Newsletter AECnews.  
     






Printable version Bookmark this page Notify a colleague or friend about this pageHome | Terms of Use | Privacy Statement | Link to AECinfo
AECinfo is a member of Docu Group, the world's largest building products information network.



Copyright © 1996–2008 AECinfo.com