sizes (nominal*)

*Actual length and width 1/8" shorter.
**Also available in lengths of 10' and 12'.

specifications(substrate)
Density, lb./ft.³ .............................................................24-26
Hardness (Janka Ball) lbs. (min.) ..................................200
Tensile Strength, psi ...............................................350-600
Mod. of Rupture, psi ...............................................650-900
Mod. of Elasticity, psi ...............................................69,000
Water absorption by vol. (max.)
    (2 hr. immers.) ..............................................................5%
    (24 hr. immers.) ..........................................................15%
Expansion from 50% to 90% rel. hum.
    (max.) .......................................................................0.25%
Thermal Conductivity (k factor).................................... 0.42
R-value ............................................................................1.11
NRC ................................................................................0.20
Flame Spread .................................................Class III (or C)

architectural specification (short form)
All___________ as shown on drawings shall be Homasote Burlap Panels as manufactured by the Homasote Company, West Trenton, N.J., and installed in accordance with current Homasote installation instructions.

packaging, storage & protection
Panels should be kept in original packages, stored in a dry place indoors or on a raised platform, protected from weather damage.

Temperature and humidity conditions closely approximating those which will exist when building is occupied shall be maintained before, during and after the application of Burlap Panels. Installation shall not be made when building is excessively cold, hot and/or damp.

All Burlap Panels shall be removed from protective packaging not less than 24 hours prior to application and placed singly and vertically around walls exposed to environmental temperature and humidity conditions.

Panels should be observed carefully at t his time to determine and insure desired effect with respect to color, texture, panel sequence, etc. It may be found necessary to invert certain panels to alter direction of grain, color or weave to achieve best results.

During installation, Burlap Panels must be applied leaving 1/8" expansion space between adjoining panels. Allow 1/4" spacing at floor, ceiling and around windows and door frames, etc. Framing must not exceed 16" o.c. Panel edges must be supported at all times. As with any natural fabric material, care should be taken in handling panels with clean hands.

The surface and its appearance can be kept fresh and clean with negligible maintenance. Soils or grime can be removed by brush-vacuuming, or with soap or detergent and water. Do not flood. Use a wet (not soaked) rag, sponge or soft bristled scrub brush. Remove soap or detergent using a clean cloth or sponge wet with clean water. Do not flood. Exposure to u/v light will cause color shading.

materials, finishes
Burlap Panels are a prefinished paneling with a natural color jute fabric that does not require additional finishing. If, however, an alternate color is required to fit a particular design, the jute fabric may be painted. See installation instruction sheet #BP-8-802-2.

Also available are Homasote joint and trim moldings in low lustre black or white for a neat, professional finish. These moldings include: cap, inside and outside corners, and "H" for butt joints. |
 

availability

Homasote building products are available throughout the United States and Canada from local building material dealers. Dealers should have samples and literature describing all Homasote products. If not, write directly to Homasote Company.