The Magnuform III Series offers an aesthetically styled rectangular housing with sharp cutoff and a variety of distributions for many applications. Magnuform’s clean appearance and wide range of wattages and sources make it an excellent lighting solution for these applications:

• Shopping Centers
• Malls
• Commercial and Industrial complexes
• Roadway
• Any area where luminaire styling contributes to the visual environment

Lightweight, rugged, one piece formed and welded aluminum insures smooth construction and weatherproof integrity. The luminaire is pre-drilled for mounting to pole or wall.

Ballast is factory mounted to a galvanized steel end support which anchors to the arm for rigidity. 180°C insulation, -20°F starting (-40°F HPS), 60 Hz, HPF ballast. 50 Hz available — consult factory.

Extruded frame with rigid corner bracing and die cast zinc latches to permit tool-free entry for servicing. The door has high quality gasketing to seal against entry of insects, dirt, and moisture. Decorative silk screening provides for concealment of electrical compartment.

Flat, tempered and impact resistant glass

Two mils minimum of electrostatically applied powder coating, high temperature bonded to the surface for maximum adherence and finish hardness. Standard finishes include bronze, black, gray, and white.

Gasketed for all weather protection. UL 1572, suitable for wet locations. CSA-NRTL/C certified for outdoor use, IP Suitability, IP55.

Heavy duty mogul base porcelain with spring loaded center contact for positive grip and vibration resistance.

ORDERING INFORMATION

1. Shipped with lamp included. (ED28 shape)
2. Type II/III asymmetric distribution shipped in P wide coverage position — socket is field adjustable.
Note: Above units are Quad-Tap® (120 / 208 / 240/277 volt.) For Tri-Tap (120 / 277 / 347V) change 8 to 6; for 480V, change 8 to 5.
All units are bronze Lektrocote finish. For other colors change 1 to Black-2; Gray-3; White-4.
Note: Poles must be ordered separately. See SSP poles for steel poles. See SAP poles for aluminum poles.

ORDERING INFORMATION

1. Type II/III asymmetric distribution shipped in P wide coverage position — socket is field adjustable.
Note: Above units are Quad-Tap® (120 / 208 / 240/277 volt.) For Tri-Tap (120 / 277 / 347V) change 8 to 6; for 480V, change 8 to 5.
All units are bronze Lektrocote finish. For other colors change 1 to Black-2; Gray-3; White-4.
Note: Poles must be ordered separately. See SSP poles for steel poles. See SAP poles for aluminum poles.

Sample Catalog Number
CATALOG LOGIC:

1. Select desired mounting adapter.
2. Available with 250W HPS, 400W HPS / MH only.

Sample Catalog Number
CATALOG LOGIC:

2. Catalog number indicates bronze finish. For other colors change 1 to Black-2; Gray-3; White-4.
3. Use MAL-10 arms.