MPS offers a distinctive luminaire combining an indirect lighting system with an aesthetic housing design. It provides a uniform level of illumination for safety and security while also enhancing the visual environment during daylight hours. Ideal for shopping centers, malls, parking areas, walkways, college campuses, and commercial or industrial complexes.

Consists of a one-piece formed housing with a clear acrylic enclosure and cast aluminum base. A gasketed top cover seals the unit for weather-tight operation.

180°C insulation, -20°F starting (-40°F HPS), 60 Hz, HPF ballast. Capacitor and starter (HPS units) are isolated in lower housing away from ballast and lamp for cool operation and long life. 50 Hz available, consult factory.

Highly specular reflector system provides sharp cutoff and a uniform illumination. The upper and lower reflector efficiently collect and distribute the lamp lumens and provide an IES Type V symmetrical distribution. MPS utilizes a mogul base socket.

Fixtures have a cast fitter for slipfitting 2 3/8" to 3" O.D. tenons.

Two mils minimum of electrostatically applied powder coating, high temperature bonded to the surface for maximum adherence and finish hardness.

Gasketed for all weather protection. U.L. 1572, suitable for wet locations. CSA — NRTL/C certified for outdoor use, IP Suitability, IP55.

ORDERING INFORMATION: MPS


Note: Above units are Quad-Tap^® (120/280/240/277 volt.) If 480 volt is desired change 8 to 5. For 347 volt change to 6. Above units have clear enclosures. For other enclosure finishes change C in catalog logic to B-Bronze/Clear or S-Smoke/Clear.
Note: Above units have bronze housing. For other finishes change last digit from 1 to 2-Black, or 3-Gray.
Note: Poles must be ordered separately. See Ordering Information: Poles.

1. Mogul base lamps not included.

ORDERING INFORMATION: Poles

1. Maximum allowable EPA is based on steady winds of 80 and 100 MPH with gusts to 104 and 130 MPH respectively.

2. Standard finish is Lektrocote^® bronze. For other finishes change M51 in catalog logic to Black-M50 or Gray-M53.

4. Factory supplied template must be used when setting anchor bolts, Hubbell Lighting will deny any claim for incorrect placement of anchorage resulting from failure to use factory supplied templates.

Note: See Pole Selection Guide before ordering.

Sample Catalog Number
CATALOG LOGIC:

Sample Catalog Number
CATALOG LOGIC: