Round tapered shaft One or two piece construction 2-3/8'' OD x 5'' long tenon Ground lug standard Standard finish, iron oxide rust inhibitive primer 4'' x 6'' reinforced handhole Steel base plate Four L shaped galvanized anchor bolts with bolt template

ORDERING INFORMATION

ORDERING INFORMATION

1. Maximum allowable EPA is based on steady winds of 80, 100, and 120 MPH with gusts to 104, 130, and 156 MPH respectively. All calculations are based on a minimum yield of 48,000 PSI.
2. Factory supplied templates must be used when setting anchor bolts. Hubbell Lighting will deny any claim for incorrect anchorage placement resulting from failure to use factory supplied template.
3. Seventh digit in catalog number is gauge: T = 0.1196", N = 0.1793" and J = 0.1793" bottom, 0.1196" top (two sections)
4. Iron oxide rust inhibitive primer standard. See Options for other finishes.
Note: Vibration dampers available, consult factory.
Note: Refer to Pole Selection Guide prior to selecting equipment.

OPTIONS

The factory options listed below are available for the RTS / RLS Standard/Heavy duty floodlight poles.
They must be ordered with the pole by adding the appropriate suffix to the catalog number.

Note: See Factory Options section for illustrations and complete descriptions.