1 . Using a scale, or the Clamping Unit itself measure and mark location
on mounting surface for each mounting hole of the lower Clamping Unit. Note that all
mounting holes are spaced at even increments.
2. Drill appropriate size hole for particular MULTI-CLAMP series being
installed.
3. Place Self-tapping Adapter into speed wrench and insert into each hole until seated
securely
4. Align lower Clamping Unit over Self-tapping Adapters and position by
placing the Adapters through mounting holes.
5. Thread Stacking Nut onto each Self-tapping Adapter until finger tight.
6. Tighten all Stacking Nuts securely and proceed with remainder of installation.
STANDARD BOLT, LOCKWASHER AND STACKING NUT FOR DRILLED HOLE (A)
THREAD ADAPTER FOR DRILLED HOLE (B)
1. (A & B) Using a scale, or the Clamping Unit itself, measure and
mark location on mounting surface for each mounting hole of the lower Clamping Unit. Note
that all mounting holes are spaced at even increments.
2. (A & B) Drill appropriate size hole for particular MULTI-CLAMP series being
installed.
3. (A) Position lower Clamping Unit over tapped holes. Place standard bolt
and lockwasher through drilled hole and through lower Clamping Unit. Attach with stacking
nut finger tight.
4. (A) Tighten securely and proceed with remainder of installation.
3. (B) Assemble required number of Stacking Nuts and Thread Adapters for
each mounting hole.
4. (B) Position lower Clamping Unit over drilled holes. Place threaded portion of
assembled Thread Adapter-Stacking Nut through both lower clamping unit mounting hole and
drilled hole.
5. (B) Attach lockwasher and nut. Tighten to secure Clamping Unit and proceed with
remainder of installation.
