|
IntroCoat
Texture |
PRODUCT DESCRIPTION |
| IntroCoat Texture is a heavy-duty, pre-mixed,
textured, pigmented acrylic polymer-based coating containing mildewcides and biocides.
Designed to provide an attractive, durable textured appearance on interior surfaces. |
GENERAL INFORMATION |
| Type : Styrenated Acrylic Polymer Grades : Textured (Trowel Grade)
Sizes : Available in five (5) gallon pails
Colors : 800 standard or custom tinting available
Available : Platinum and Gold Series |
RECOMMENDED USE |
IntroCoat Texture is used
as an interior decorative coating for masonry, concrete and drywall, as well as properly
prepared wood and plaster. When properly applied, IntroCoat Texture provides a
long-lasting mildew resistant coating for commercial, industrial and residential
interiors. |
TECHNICAL DATA |
Total solids by Wt. (%) |
78 + / -1 |
Total solids by Vol. (%) |
63 |
pH |
9.0 – 9.2 |
Viscosity |
115 – 125 Ku |
Weight Per Gallon |
14.5 – 15 lbs. |
Dry Time (to touch) |
2-4 hours |
Dry Time (to cure) |
24 hours |
Average Humidity |
60% |
|
LIMITATIONS |
To be applied only to
clean, dry, sound interior walls and ceilings. Do not apply when room temperature is below
45 degrees F or expected to drop below 45 degrees F within a 24 hour period. Protect from
freezing. Contact your IntroCoat representative for details or call the Technical Hotline
at 1-800-717-0987. |
SURFACE PREPARATION |
All surfaces to be coated
must be clean, dry and free of dirt, old wall vinyl and adhesive, wax, oil, chalk, loose
material or other surface contaminants which would interfere with proper adhesion.
Repair cracks, holes and surface
imperfections with a patching compound or IntroCoat Texture. All surfaces should be primed
with an application of MillKill III, when necessary, and allowed to dry completely. |
MIXING INSTRUCTIONS |
| For best results, always mix IntroCoat
Texture thoroughly using a paddle mixer before application. Create an even consistency to
insure no settling. |
COATING APPLICATION |
IntroCoat Texture is ready
to use from its container, no thinning is necessary. Stir thoroughly before application to
create an even consistency and insure no settling. Prime surface with MillKill III, when
necessary, and allow to dry thoroughly. Apply with a textured roller, trowel or air driven
texture pump, such as a hopper gun or larger texture equipment. Contact your IntroCoat
representative for spray equipment details. Desired finishes vary according to applicator. |
COVERAGE RATE |
Coverage will vary greatly
depending on the applicator’s technique, surface condition and desired pattern.
Reference Texture Finish Coverage Data Guide. |
TECHNICAL SERVICES |
| IntroCoat offers a full technical support for
the IntroCoat Wall Texture System. Contact your local representative for assistance and
information. |
LIMITED WARRANTY |
IntroCoat Wall Texture
System is warranted against feeding mildew for five (5) years for Gold System and ten (10)
years of Platinum Series. For Warranty information, contact your local representative.
PRECAUTION :
DO NOT TAKE INTERNALLY. KEEP OUT OF REACH OF CHILDREN. AVOID EYE CONTACT. AVOID PROLONGED
CONTACT WITH SKIN. |
IntroCoat Wall Texture Systems |
