- Remove masking tape and clean all adjacent surfaces at the
end of each work day. Do not leave masking tape or waste materials in place until hard,
generally not to exceed 12 hours.
PART 2 – PRODUCTS
2.01 MANUFACTURER:
Provide IntroCoat products manufactured by IntroCoat, Inc.,
Perry,Georgia, 1-800-717-0987. Texture to be : ________________________
2.02 MATERIALS:
- MATERIAL QUALITY: Finished and fully cured materials shall
have the following minimum performance characteristics :
Moisture Vapor Permeability ASTM D-1653 & 96 30 Perms
or greater
Hardness and Abrasion Resistance
| - Hardness |
- D-3363 Pencile |
3B |
|
- D – 2134 Sward |
29 |
|
- D – 1474 Knoop |
4.8 |
| - Abrasion |
- D – 4060 Taber |
Passes |
|
- D – 2486 Scrubbability |
Passes |
|
- D – 4828 Washability |
Passes |
| Mildew Resistance |
Four Week Agar Plate Test |
"0" Growth Rating |
NOTE: Above testing results are standards
for products. These results can vary based on grade of choice. Specific ratings available
upon specific texture specified from IntroCoat, Inc.
Color Pigments : All pigments shall be pure, non –
fading and bleach resistant.
Color Selection : Provide at least sixty factory colors and
factory customer color service.
Other manufacturer’s products which
comply with the above qualitative and selection requirements may be considered by
Architect provided such products are submitted to Architect for review (10 days) prior to
bidding and with sufficient time allowed for evaluation prior to bidding. Attempts to
short cut the specified product substitution process could result in disqualification of
the proposed substitute product.
PART 3 – EXECUTION
3.01 GENERAL :
Perform preparation and cleaning
procedures in accordance with manufacturer’s recommendations and as herein specified,
for each particular substrate condition.
|
