A. Synthetic (man-made) Marble: Provide, where indicated on the Drawings, synthetic marble products as manufactured by:

1. Introsul, Inc.

Perry, GA

912/987-3185

Donald J. Svoboda

2.3 VANITY COUNTER TOPS

A. Vanity Counter Tops: Provide, where indicated on the Drawing, synthetic marble vanity tops in accordance with the criteria indicated above and possessing the following physical characteristics:

1.  Vanity counter tops shall have manufacturer's dripless edge profile to prevent splashed water from dripping from vanity surface and damaging flooring materials adjacent to the vanity top.

2. Vanity counter tops shall have factory-drilled holes for faucets in the location and of the configuration required to accommodate fixtures specified on the Drawings and in the Specifications.

3. Vanity counter tops shall have factory-finished cutout to receive undermount vitreous china bowls, as specified on the Drawings or herein below, to be furnished by vanity manufacturer.

a. Underside of vanity counter tops shall have cast-in place metal anchors to receive screws and clips to secure undermount vitreous china bowl.  Clips, screws and anchors shall be provided by the vanity counter top manufacturer.

4. Vanity counter tops shall have four inch (4") high integral (coved) backsplash as measured from the top surface of the vanity counter top.

5. Vanity counter tops shall be selected from manufacturers standard colors. custom colors or derivatives will not be accepted.

6. Vanity counter tops shall be of manufacturer's standard materials, complying with the above characteristics, and shall be a minimum of three quarters of an inch (3/4") in thickness.

7. Vanity counter tops shall include, where indicated on the Drawings, four inch (4") tall by one-half inch (1/2") thick end splashes at all vanity counter tops ends that are adjacent to wall surfaces.

8. Vanity counter top units shall include, where indicated on the Drawings, finished, dripless edge ends, as delineated above, at all vanity counter top ends that are not adjacent to wall surfaces.

9. Vanity counter top units shall include, where indicated on the Drawings, aprons of either five inches (5") in width-or-ten inches (10") in width, by the length of the vanity top, by one-quarter (1/4") thick at the front ad at ends that are not adjacent to wall surfaces, unless millwork or cabinets are indicated on the drawings.