- 8' to 20' mounting heights
- Triangular 3-bolt base with spun aluminum collar
- Luminaires may be mounted on tenons, brackets, or slipfitted
on the pole top
SPECIFICATIONS
All aluminum alloys shall comply with metallurgical and
mechanical properties set forth in the Aluminum Association Standards.
SHAFT: The shaft shall be extruded from
all new seamless 6063 alloy aluminum and shall be heat treated to produce a T6 temper. The
shaft may be drilled for mounting luminaires. Standards shall be polished with fine grain
aluminum oxide cloths, resulting in a high quality circumferential satin brushed finish.
After finishing each standard shall be fully tire wrapped with neutral PH krinkle/kraft
paper for protection in shipment.
ANCHOR BASE: The anchor base is cast from
A356 alloy aluminum and shall be heat treated to a T6 condition. The shaft shall be
inserted into the anchor base casting. The anchor base casting and the shaft shall be
joined by a continuous circumferential weld at the outside top and inside bottom of the
anchor base.
WIRE ACCESS: A 1-1/2" diameter wire
access hole shall be incorporated in the anchor base casting and shall be completely
concealed by the spun aluminum collar. To comply with the NEC, handholes are available as
an accessory on 4" and 5" diameter standards, but not 3". These shall be
peripherally reinforced, flush covered, centered 18" above the bottom of the
standard.
ANCHOR BOLTS: Each anchor base standard
shall include three 3/4"-10 x 15" steel hot dip galvanized anchor bolts each
with two nuts, two flat washers, and one lock washer.
SPECIAL FINISHES : Natural anodize,
duranodic, or painted finishes may be specified as an addition to the satin brushed
finish, if required. All aluminum parts and accessories shall receive a finish similar to
that specified. |
