Hold Down Clip for 2" (5cm) Thick Lay-In Panels

A Non-rusting Hold Down Clip fitting Fiberglass Ceiling Grids

The new clip is made of PVC and holds 2" to 2.5" (5 to 6.5 cm) thick lay-in panels. Often these panels are laminated with 0.03" FRP on both sides of insulating foam.

                   Non-Rusting Hold Down Clip for Metal Ceiling Grids

Fits Most Metal Grids and Holds Down Thin Panels

• Made of non-rusting plastic - PVC
• Designed to hold down nominal 0.09" thick Fiberglass lay-in panels
• Available in custom lengths to tailor the holding power you need
• Standard, stocked length of 1.25"

Aids Installation of Grid

• Allows you to anchor a main runner or cross tee to the wall / wall molding
• Fits on KEELGRID Tee and has "ears" at about 90 degrees which can be riveted to wall.
• Recommened for use on Main Runner and Cross Tee bridges to Wall Molding on two adjacent walls
• Replaces conventional Splice Clip (only for the Tee-to-Wall bridge --- and only about half of these bridges)

Shown below in a rough picture is the wall clip resting on the wall angle and clipped to a portion of a main runner tee or cross tee.