PART 1: GENERAL

1.01 DESCRIPTION

This section describes the requirements for furnishing and installing fiberglass reinforced plastic panels according to manufacturer's recommendations.

1.02 SUBMITTALS:

Submit in accordance with Section (Insert Section Number)

1. Two samples of each type of panel each type of trim and fastener.
2. Shop Drawings: Indicate the location and dimension of joints and fastener attachment.
3. Installation Guide #6211.

1.03 QUALITY ASSURANCE

Provide panels and molding only from the manufacturer specified to ensure warranty and color  harmonization of accessories.

1.04 DELIVERY, STORAGE, AND HANDLING:

1. Delivery of Materials: Package sheets on skids or pallets for shipment to project site.
2. Storage of Materials: Store panels indoors in a dry place at the project site.
3. Handling: Remove foreign matter from face of panel by use of a soft bristle brush, avoiding abrasive action.

1.05 PROJECT CONDITIONS:

1. Installation shall not begin until building is enclosed, permanent heating and cooling equipment is in operation, and residual moisture from plaster, concrete or terrazzo work has dissipated
2. During installation and for not less than 48 hours before, maintain an ambient temperature and relative humidity within limits required by type of adhesive used and recommendation adhesive manufacturer.
3. Provide ventilation to disperse fumes during application of adhesive as recommended by the adhesive manufacturer.