architecture - engineering - construction
AECinfo.com
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share
  Kemlite Company   Glasbord  

Glasbord - Page 6

   

Glasbord

SECTION 09986 SANITARY WALL FINISH KEMLITE® FIBERGLASS REINFORCED PLASTIC PANELS.

PART 2: PRODUCTS

2.01 MATERIALS

  1. Acceptable panels: (Insert from Item 1,2,3 or 4 Part A.)
  2. Division Bars, Corner Trim: Panel manufacturer's standard length extruded vinyl pieces; longest length possible - to eliminate end joints (Insert from Item 1,2,3, or 4 Part B)
  3. Fasteners: Non-corrosive drive rivets. (Insert from Item 1,2, or 3 Part C.)

PART 3: EXECUTION

3.01 PREPARATION

  1. Examine backup surfaces to determine that corners are plumb and straight, surfaces are smooth, uniform, clean and free from foreign matter, nails countersunk, joints and cracks filled flush and smooth with the adjoining surface.
  2. Do not begin installation until backup surfaces are put into satisfactory condition.

3.02 APPLICATION

  1. Do all cutting and drilling with carbide tipped saw blades or drill bits, or cut with snips.
  1. Install panels with manufacturer's recommended gap for panel field and corner joints.
  1. Fastener holes in the panels must be predrilled 1/8" (3.2 mm) oversize.
  1. For trowel type and application of adhesive, follow adhesive manufacturers recommendation.
  1. Using products acceptable to manufacturer, install the frp panel system in accordance with panel manufacturer's printed instructions, Installation Guide #6211.

3.03 CLEANING.

  1. Remove any adhesive or excessive sealant from panel face using solvent or cleaner recommended by panel manufacturer.

Kemlite, are registered trademarks of Kemlite Company, Inc.



Request for Information / Request a Catalog from Kemlite Company
 
 
 
To request more information from Kemlite Company, please complete the form below.
 
*Name:    
*Email:    
Company:    
*Type:    
Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
Please add me to the mailing list for the free monthly e-Newsletter AECnews.