DRYWALL ACCESS PANELS

L-DWA /  L-DWB / L-DWC

GENERAL DESCRIPTION

L-DWA : For installation in sheet rock or drywall before the board is up. Allows convenient access for inspection or service to components of plumbing, heating, air conditioning and electrical systems. The frame has an integral 5/8" flange set back for drywall cement ground and our unique off-set concealed hinging allows the door panel to swing away from and into the frame.

L-DWB: To be installed in sheet rock or drywall after the board is up, taped and sanded. This is accomplished by the use of a minimal 1/2" rolled edge flange on all sides. The wall opening is completely covered providing a wall hugging, finished edge that eliminates the need for taping and sanding.

L-DWC: This panel is designed for flush installation in drywall surfaces. The outer frame has a special grooved drywall bead configuration with a textured surface so that joint compound can be applied in sufficient thickness to cover and conceal the flange. This unique design provides additional strength for the joint compound. The joint compound is then applied at the same time the drywall joints are finished. When installed properly, only the door panel remains exposed.

SPECIFICATION

FRAME: .060-6063-T5 extruded aluminum

PANELS: 14 gauge galvanized bonderized steel

HINGE: Concealed zinc plated continuous

LATCH: Flush mounted screwdriver operated cam latch.

Optional key lock or tamper resistant cam latch.

FINISH: Galvanized bonderized / mill

* ADDITIONAL STANDARD SIZES FOR L-DWB SEE L-MP TABLE (PAGE 4)

CALL 1-800-LARSENS / FAX (612) 571-6900