Portables & T Mold Boards

DTM BOARDS (DELUXE "T" MOLD)
SPECIFICATION: Writing surface is Lemco porcelain enamel chalk or marker finish on steel (complying with PEI Spec. S104). Tackboard is Lemco No. 300 fabric or vinyl on 1/4" natural cork. Core material is honeycomb with a 3' wide perimeter band of particle board. Total thickness of the board is 1 1/4". DTM will be backed with .015 aluminum foil and a face sheet of writing surface or cork. Edges of all panels to have a black plastic "T" mold. Molding is to have retainer driven from the back of the panel through barbed leg of "T" mold at not more than 24" on center. Fabric covering on tackboards will be glued to cork. Overlapping edges will be forced into kerfed edges of particle board prior to installing edge trim. Corners of all panels will have a 3" radius. Chalktray and maprail are continuous on all writing boards, in a finish selected by architect. "L" bracket installation.

TM BOARDS ("T" MOLD)
SPECIFICATION: Writing surface is Lemco porcelain enamel chalk or marker finish on steel (complying with PEI Spec. S104). Tackboard is Lemco No. 300 fabric or vinyl on 1/4" natural cork. Core material is particle board. Particle board thickness will accommodate writing or tack surface, so that overall thickness of the TM board shall be 3/4". Backing sheet of aluminum foil is required on core of writing surface. Edges of all panels will have a black plastic "T" mold. Molding is to have retainers driven from the back of the panel through the barbed leg of "T" mold at no more than 24" on center. Fabric covering on tackboards will be glued to cork. Overlapping edges are to be forced into kerfed edges of particle board prior to installing edge trim. Corners of all panels will have a 3/4" radius. Chalktray and maprail are continuous on all writing boards, in a finish selected by the architect. "l" brackets installation. Section drawings and installation instructions available upon request.

PORTABLE BOARDS CHALKBOARDS MARKERBOARDS TACKBOARDS

PORTABLE CHALK & TACKBOARDS
MODEL 825 MODEL 800
These units have been used extensively in school and churches throughout the United States.

Portable details have been engineered for quality and durability. All connecting trim sections are corner locked and reinforced with channels or angles within the tubular construction. Standard construction consists of a chalkboard on one side and tackboard on the reverse side. These surfaces plus markerboard can be used in any combination. The model 800 has a release and lock pin located at the bottom center of the frame for easy rotation of the panel within the frame. All units have a continuous chalktray and maprail (Model 825, when ordered with chalkboard on both sides, has tray and rail on both sides). Heavy duty 4" ball bearing castors provide easy mobility on any type of floor. Two of the castors provided are locking. All units ar designed to go through a standard size door opening.

*Standard lengths: 4', 5', 6', and 8'. Standard height: 6' 6".

Modification to size can be made.

Specification: Provide ______________ (insert quantity) of the Lemco Model ________________ (insert model 800 or 825). Size to be ________. Chalk or marker surface to be ______________ . Tackboard surface to be _____________ . Aluminum tub and channel frame sections to be of extruded aluminum with a minimum of 1/8" wall. Finish to be etched and clear satin or bronze anodized (select one). All trim sections will be assembled with channel or angle reinforcing corner locks. Chalktray and maprail to be continuous on chalkboard size of all units. Castors will be 4" diameter, hard rubber. Two castors on each unit to be locking (for model 800 only: Pivot point consists of a 1/2" steel rod within a self lubricating bronze bushing and a spring loaded release /locking pin).