INCLUSIONS

• Trunnion - Lamp Shield/Color Holder
• Three Foot, 4-Wire Lead (UL)
• Three Foot, 3-Wire Lead (non-UL)

ILLUMINATION FIELD

38° spread parallel to fixture = (throw x 0.69) + 4'

150° spread perpendicular to fixture = throw x 7.46

INTENSITY

* or equivalent lamp

To find light output in footcandles (fc) at any distance: CBCP / (throw distance)² = fc

- For proper performance, compatible dimmer must be properly trimmed and maintained.

- Fixture performance may vary between dimmer types.

SPECIFICATIONS

The luminaire shall be a UL/C-UL Listed 40w fluorescent striplight with an integral 120V Class P dimming ballast (containing no PCB's). The housing shall be of extruded aluminum with an aluminum ballast plate and end caps. The housing shall be designed to provide an integral reflecting surface, optimizing light output, and shall accept snap-on clear extruded plastic lamp shields. The lamp shields shall also be designed to allow plastic color media to be secured in place conveniently. The unit shall be able to be supported using either standard triangular trunnion or L brackets. The electrical configuration shall allow the unit to be dimmed using most existing theatrical dimmers.

Relamping shall be accomplished by removing the lamp shields and snapping the lamp out of the lamp holders, no tools shall be required. Relamping shall not disturb the prefocused tamp/reflector alignment.

The luminaire shall be supplied with two 16 gauge steel single mount trunnion for overhead or floor use, two plastic lamp shields, and four wire leads (UL) or three wire leads (non-UL) encased in fiberglass sleeving.

The unit shall be supplied with an aluminum finish.

Copyright © 1996 Lighting & Electronics, Inc.