1601 PARALLEL ARM INSTALLATION
Installation Drawings
Parallel Arm+ Door Sizes And Catalog Numbers
DIMENSIONAL INFORMATION SHOWN IN INCHES
(MILLIMETERS)
| S MINIMUM TOP RAIL 5/8" (16mm) FRAME STOP |
T TEMPLATE POSITION FOR 100º DOOR OPENING |
| WITHOUT DROP PLATE |
WITH DROP PLATE 1968 |
| 1601 |
1681 |
1601 |
1681 |
1601 1681 |
| 5 (127) |
4 (102) |
3-1/8 (79) |
2-1/8 (54) |
3-3/8 (86) |
| 2-1/4 (57) |
+ This door sizing information also applies to Corner
Bracket mounted Closers.
Normal Power Range Closers 1
| Maximum Door Size Wood or
Metal Inches (meters) |
Power Setting* Number of
360º Turns of 3/16" Hex Drive Power Adjustment Shaft |
Norton Catalog Number for
Closing |
| Interior |
Exterior |
Non-Hold Open |
Hold Open |
| 34 (0.85) |
3 |
5 |
(P)1601 (P)1681 |
(P)1601 H |
| 36 (0.90) |
5 |
7 |
| 40(1.00) |
7 |
10 |
| 44(1.10) |
10 |
14 |
| 48 (1.20) |
13 |
16 |
| * 18-360º Turns Maximum Available |
1 Power of closer can be adjusted to conform
to the sizing requirements outlined in ANSI A 156.4-1980, Standards for Door
Controls-Closers.
A.D.A. Accessibility Code Closers with low opening
resistance. 2
| Maximum Door Size Wood or
Metal Inches (meters) |
Power Setting* Number of
360º Turns of 3/16" Hex Drive Power Adjustment Shaft |
Norton Catalog Number for
Closing |
| Interior |
Exterior |
Non-Hold-Open |
Hold-Open |
| 34 (0.85) |
2 |
8 |
(P)1601BF (P)1681BF |
(P)1601BF-H |
| 36 (0.90) |
2 |
9 |
| 40 (1.00) |
3 |
12 |
| 44(1.10) |
4 |
Use 1601 Closer |
| 48 (1.20) |
5 |
*
18-360º Turns Maximum Available |
2 Power of closer can be adjusted to
conform to the sizing requirements outlined in A.D.A and ANSI A 117.1-1980, Specifications
for Making Buildings and Facilities Accessible To and Usable By Physically
*Closer is factory set at zero turns or the lowest setting.
All dimensions are for reference only. Dimensions in parentheses are
millimeters unless noted otherwise. Door sizing information is based on installation on
standard weight doors, 7'0" (2.13 m) high 1 -3/4" (44 mm) thick; hung on
anti-friction hinges and operating under normal conditions. Doors in excess of 7'8"
(2.34mm) high or 1 -3/4" (44 mm) thick; unusually heavy doors: doors templated for
openings beyond 150° or doors subject to wind or
draft conditions will generally require additional turns of POWER ADJUSTMENT SHAFT from
that shown in the chart.
|
