1601 ACCESSORIES

The following accessories are available for use with Series1601 door closers.

The accessories are divided into the basic groups of closer mounting: Regular Arm, Top Jamb, Parallel Arm, Parallel Rigid Arm and Corner Bracket. These groups include Arm Brackets for Non-Hold-Open and Hold-Open installations; and Closer Mounting Brackets and Plates.

The initial statement in each paragraph outlines the situation for which the accessory is intended. Example:

Molded/Bull Nose Trim: You attempt to mount a Regular Arm, Non-Hold-Open closer on a frame with molded or bull nose trim. The convex frame surface prevents use of the standard non-hold-open mounting shoe.

By referring to the descriptions that follow, the specifier can determine that it would require a 2403 bracket to complete the installation.

Regular Arm Closers: Brackets for Non-Hold-Open Arms

Molded/Bull Nose Trim -- #2403 Bracket: For use where the door frame has molded or bull nose trim which will not accept a standard non-hold-open shoe. The bracket is mortised into the frame rabbet, and projects beyond the face of the frame. It will accommodate a frame rabbet up to 2" (51 mm) deep.

Molded/Bull Nose Trim -- #2403-3/4 Bracket: This bracket is similar to -- but longer than -- the 2403 bracket. It is designed to accomodate frame rabbets from 2" to 2-7/8" (51 mm to 73 mm) deep.

Regular Arm Closers: Bracket: for Hold-Open Arms

Molded/Bull Nose Trim -- #80 Bracket: For use where the door frame has molded or bull nose trim which will not accept a standard hold-open shoe. It is mortised into the frame rabbet, and projects beyond the face of the frame. It will accommodate a rabbet up to 2" (51 mm) deep. This bracket is used in combination with the standard hold-open mounting shoe.

Molded/Bull Nose Trim -- #80-3/4 Bracket: This bracket is similar to -- but longer than -- the 80 bracket, and will accommodate frame rabbets from 2" to 2-7/8" (51 mm to 73 mm) deep. This bracket is used in combination with the standard hold-open mounting shoe.