 6600/6700 SWITCHES & SCANNERS
The switches and scanners shown here interface with the
Series 6600 and Series 6700 PowerMatic® products. The specifics of each application will determine the type
of switch(es) or scanner(s) that are appropriate:
Note: Careful consideration should be given to the location
of switches and/or scanners relative to their proximity to the door and the door's
direction of swing.
Switches, sensors and relays are not included with the
PowerMatic® door controls. These peripheral items must be ordered separately.
No. 660 |
Wall Switches
(660 & 661) These switches are Normally
Open Momentary Contact SPST press type wall switches with a wide 4-1/2" (114mm)
square pressure pad. They are rated tori 5 Amps. 250 VAC. The No. 660 and No. 661 wall
switches install flush with the wall in a 2 gang electrical box, supplied. Both switches
are suitable for exterior use or for surface mounted applications when mounted in a
compatible 2 gang electrical box, supplied by others. |
No. 661 |
|
 |
Frame Switch
(662) This switch is a Normally Open or
Normally Closed Momentary Contact SPDT push button type switch with a 4-1/2" (114mm)
high, 1-3/4" (44mm) wide, 1-1/2" (38mm) deep switch. For use where wall
conditions will not permit use of a wall switch or where a frame mounted switch is
preferred. This switch is rated for 20 Amps. 125 VAC. |
|
Retro-Reflective
Beam Type Sensor (664) Functions as a
Normally Open Momentary Contact switch. Rated for .100 Amps. at 24VDC. It consists of a
sensor unit mounted in a two gang electrical box and a simple reflector to reflect the red
photoelectric beam back to the sensor and a cover plate. Sensor unit mounts flush with the
wall and has a range of 30 feet. Environmentally it has an operational temperature range
of minus (-)4° to plus (+)158° Farenheit. This unit must be powered from the PowerMatic™
unit. |
|
