 6600/6700 SWITCHES & SCANNERS
The switches and scanners shown here interface with the
Series 6600 and Series 6700 PowerMatic® products. The specifics of each application will determine the type
of switch(es) or scanner(s) that are appropriate:
Note: Careful consideration should be given to the location
of switches and/or scanners relative to their proximity to the door and the door's
direction of swing.
Switches, sensors and relays are not included with the
PowerMatic® door controls. These peripheral items must be ordered separately.
 |
Single Channel Radio Frequency
Transmitter (666) This transmitter is
supplied standard with all units having an "RF1" suffix. It is a hand held
transmitter with a slip-on belt clip for convenience.
Dimensions:- 4" H x 1-1/2" W x 1" D (102H x
38W x 25 D)
Power: - Standard 9 Volt Alkaline Battery |
 |
Security Plate (668) This plate is packed standard with each unit. It is intended to
conceal the "On-Off-H/O" and "Release" switches to prevent them from
being tampered with. A "knockout" is provided in the plate, if it is desirable
to have just the "Release" switch accessible. |
 |
Wireless Transmitter/Wall Switch -
Single Channel Radio Frequency Operation (669) This product is a surface mounted transmitter that may be used in conjunction
with the "RF1" feature of a PowerMatic® unit. It transmits a radio frequency signal to the "RF1 "
receiver to initiate the power operator or power assist function. It has a 4" (102mm)
square mounting base, a 6" (152mm) diameter pressure pad and an over all projection
of just 1-1/4" (32mm). This transmitter is highly weather resistant, but is not
recommended where hurricane force gales, salt or other corrosive atmospheres exist.
Power: - 9 Volt Alkaline Battery (Eveready No. A23 or
equal)
Temperature Range: - +32° to 120°F (0°C to + 0°C) |
| See Illustration of RF Control Module Page 11. |
RF1 Radio Frequency Receiver Kit (671) Used for converting a standard PowerMatic unit to radio frequency
control. Wireless remote operation. Consists of radio frequency receiver module, four
standoffs and four screws for mounting on back plate. Used in conjunction with 666 hand
transmitter or 669 wall mounted transmitter (Ordered separately). Option of momentary
hold-open function or maintained hold-open function may be selected at time of
installation. (See page 11 for wire connections). |
|
