architecture - engineering - construction
AECinfo.com
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share
  Norton Door Control   Norton Series 7200 Electomechanical  

Norton Series 7200 Electomechanical - Page 2

   

Norton Series 7200 Electomechanical

Yale Security Inc.

INTRODUCTION


Introduction

The Series 7200 Electromechanical Closer-Holders combine the functions of an electromechanical door holder with one of our finest door controls, the Series 7700 door closer. The 7200 features a choice of two types of hold-open functions:

  • Infinite Hold-Open (I suffix): The door will hold-open at any degree of opening up to 175° with a maximum allowable door opening of 180°.
  • Selective Hold-Open (S suffix): The door will hold open at any degree of opening, beyond a pre-set hold-open point, up to 175°, with a maximum allowable door opening of 180°. Factory set at 80°, but is adjustable to virtually any degree of door opening desired.

The Series 7200 Electromechanical Closer-Holders are available as four basic units for controlling fire/smoke doors.

Support Unit Series 7200MP (I or S): The Support Unit contains a door closer with internal holder only. These units install on either single doors or on both leafs of a pair of doors. Its hold-open function is controlled by compatible UL listed smoke detection equipment such as area/ceiling smoke detectors.

Support Unit Overhead Concealed Series 7290MP (I or S): Pull side only.

Master Unit Series 7200MPD (I or S): This unit contains an integral smoke detector, and a door closer with internal holder. The Master Unit can be used to control a single door or a pair of doors when used in conjunction with either a Slave Unit or a Tandem Unit.

Units with Integral Smoke Detectors Feature:

  • Dual Chamber lonization Sensor
  • Momentary Contact Test Switch
  • Green LED "Power-On"
  • Red LED "Alarm"
  • Latching Alarm
  • 1 set Normally Open dry alarm contacts.
  • 1 set Normally Closed dry trouble contacts.

Slave Unit Series 7200MPS (I or S): The Slave Unit contains a door closer with internal holder only. The Slave Unit hold-open function is controlled by the detector in the Master Unit. 24VDC only.

Tandem Unit Series 7200MPT (I or S): The Tandem Unit contains a door closer with internal holder only. A Master Unit signals to a control panel. The panel controls both the Master and Tandem. 120VAC only.

Additional applications include:

Connected Free Swing Releasing Device: For health care applications to allow doors with 7200 Fire/Smoke controls to be opened and closed without closer spring force. Pull side only.

Executive Door Holder/Release: RF (1) (S) Catalog Suffix. A modified Electromechanical Closer-Holder for executive offices or any door where remote RF wireless door-closing control is desired. Not intended for use on labeled doors.




Request for Information / Request a Catalog from Norton Door Control
 
 
 
To request more information from Norton Door Control, please complete the form below.
 
*Name:    
*Email:    
Company:    
*Type:    
Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
Please add me to the mailing list for the free monthly e-Newsletter AECnews.