architecture - engineering - construction
AECinfo.com
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share
  Norton Door Control   Norton Series 7200 Electomechanical  

Norton Series 7200 Electomechanical - Page 6

   

Norton Series 7200 Electomechanical

Yale Security Inc.

SERIES 7210/7250 MASTER UNITS

Pull (Hinge) Side Mounting Rigid Slide Arm and Track

Master Units with Integral Smoke Detector

Series 7210MPDI: Infinite Hold-Open
Series 7210MPDS: Selective Hold-Open

Executive™ Door Holder/Release

Series 7210RFI: Infinite Hold - Open
Series 7210RFS: Selective Hold-Open

Single Doors

Master Units with Integral Smoke Detector: Both Series 7210MPDI and Series 7210MPDS are self-contained and can be installed to control a single door.

Executive™ Door Holder/Release: Both Series 7210RFI and 7210RFS are self-contained and can be installed to control a single door.

Pairs of Doors

Master Unit x Slave Unit: Smoke Detector in the Master Unit controls its own closer-holder solenoid and the solenoid in the Slave Unit.

Master Unit x Tandem Unit: Smoke Detector in the Master Unit signals conditions (Stand-by, Trouble/Alarm) to an alarm systems panel. This panel controls the signal to the hold-open solenoids in both the Master Unit and the Tandem Unit.

Executive Door Holder x Slave Unit: Consult the factory for details of this installation.

These Closer-Holders are surface mounted to the pull (hinge) side frame face. These units require a minimum ceiling clearance of 4" (102mm) and a maximum frame reveal of 1/8" (3mm).+ The slide track mounts directly to the door. Units can be installed as shipped to accommodate doors opening to 180° with a maximum hold-open point of 175°. The buffer block assembly in the track will accommodate doors opening to 125°. An auxiliary door stop is required for doors opening beyond 125°.

+Double Egress Frames (Deep Reveals): Where the pull (hinge) side frame reveal exceeds 1/8" (3mm), a special slide arm is available to order. This arm will accommodate frame reveals in excess of 1/8" (3mm) up to 3" (76mm) with a maximum allowable door swing of 110°. Order Series 7250MPD1, 7250MPDS, 7250RFI or 7250RFS.

Door Sizes and List Numbers

Maximum* Door Size Ft. In. (meters) NORTON CATALOG NUMBER
MASTER UNIT CLOSER-HOLDER EXECUTIVE DOOR/RELEASE
INFINITE HOLD/OPEN SELECTIVE HOLD/OPEN INFINITE HOLD/OPEN SELECTIVE HOLD/OPEN
3'-4" (1.00) 7213MPDI 7213MPDS 7213RFI 7213RFS
3'--8" (1.10) 7214MPDI 7214MPDS 7214RFI 7214RFS
4'-0" (1.20) 7215MPDS 7215MPDS 7215RFI 7215RFS

*Minimum Door Size Is 2'-4" (.70 M)

Electrical Data Master Units

MASTER UNIT CATALOG NUMBER NUMBER POWER INPUT LINES* (PAIRS) OPERATING VOLTAGE (INPUT) AMPERAGE DRAW (AMPERES) (CAN BE) USED IN CONJUNCTION WITH
SMOKE DETECTOR SOLENOID COIL
STANDBY ALARM
7210MPDI-24

7210MPDS-24

1

1

7213MPDS .016@ 24VDC .035@ 24VDC .070 @ 24VDS Slave Unit 7210MPSI-24

Slave Unit 721 0DMPSS-24

7210MPDI-120

7210MPDS-120

1

1

7214MPDS .070 @ 24VDS Slave Unit 7210MPSI-24

Slave Unit 721 0MPSS-24

7210MPDI-24

7210MPDS-24

2

2

24VAC/DC for Detection Input & 120VAC for Solenoid Coil Input .035 @ 24VDS Tandem Unit 7210MPTI-120

Tamden Unit 7210MPTS-120

Electrical Data Door Holder/Release

EXECUTIVE DOOR HOLDER/RELEASE CATALOG NUMBER NUMBER POWER INPUT LINES* (PAIRS) OPERATING VOLTAGE (INPUT) 24VDC AMPERAGE DRAW (AMPERES)
SOLENOID COIL INTERRUPTING SWITCH
7210RFI-120 1 120VAC .070 @ 24VDC 015 @ 210VAC
7210RFS-120 1

*Pairs of input lines required to supply Operating Voltage or Voltages to the Unit. Pairs listed do not include signal wires to Alarm Panels nor control wires to other units' solenoids. Maximum/Minimum Operating Voltage Parameters: +10%, -15%



Request for Information / Request a Catalog from Norton Door Control
 
 
 
To request more information from Norton Door Control, please complete the form below.
 
*Name:    
*Email:    
Company:    
*Type:    
Phone:    
*Address:    
*Request:    
    (* = Mandatory field) 
Please add me to the mailing list for the free monthly e-Newsletter AECnews.