SERIES 7210/7250 SUPPORT

UNITS SURFACE MOUNTED

Pull (Hinge) Side Mounting Rigid Slide Arm and Track

Surface Mounted Support Units
Controlled Remotely by Area/Ceiling Detectors

Series 7210MPI: Infinite Hold-Open
Series 7210MPS: Selective Hold-Open

Series 7210MPI/7210MPS Surface Mounted Closer-Holders

are surface mounted to the pull (hinge) side frame face. The standard mounting for these units requires a minimum ceiling clearance of 4" (102mm) and a maximum reveal of 1/8" (3mm).⁺ The slide track mounts directly to the door.

Units can be installed as shipped to accommodate doors opening to 180° with a maximum hold-open point of 175°. The buffer block assembly in the track will accommodate doors opening to 125°. An auxiliary stop is required for doors opening beyond 125°.

The Series 7210MPI/7210MPS are intended for use with compatible U.L. listed ceiling alarm detection equipment.

⁺Double Egress Frames (Deep Reveals): Where the pull (hinge) side frame reveal exceeds 1/8" (3mm), a special slide arm is available to order. This arm will accommodate frame reveals in excess of 1/8" (3mm) up to 3" (76mm) with a maximum allowable door swing of 110°. Order Series 7250MPI or 7250MPS.

1/8" (3mm) Maximum Frame Reveal with Standard Arm⁺

Door Sizes and List Numbers

Minimum door size is 28" (.70M).

Electrical Data

Maximum/Minimum Operating Voltage Parameters: +10%, -15%