BRACKETS
Parallel Arm Closers:
Brackets for Non-Hold-Open Arms (cont'd)
Narrow Frame/Removable Stop -- #2018B Soffit Plate: For
use where a narrow frame or frame with removable stop does not permit use of the standard
soffit plate. This soffit plate may be mounted on the frame soffit or the frame rabbet
where the stop does not exceed 5/8" (16 mm) in height. All of the screw holes are in
a straight line, requiring as little as 1-1/4" (32 mm) of frame reveal to mount
bracket and maintain good closer arm geometry. Where the frame soffit is as wide as
2" (51 mm), this soffit plate may be used to clear weatherstripping that is up to
1-3/8" (35 mm) wide and 5/8" (16 mm) in height.
Blade/Applied Stop -- #2018D Soffit Plate: For use
where a blade or applied stop does not permit installation of the standard soffit plate.
Mounts to either the frame soffit or rabbet. Since this soffit plate projects 7/8"
(22 mm) less than a standard soffit plate, it requires a minimum frame reveal of
1-1/2" (38 mm). Permits closer to clear up to a 5/8" (16 mm) high stop.
Flush Transom -- #2018L Angle Bracket: For use where
rabbeted or flush transom conditions prevent installation of a soffit plate. Used in
combination with the 1618 soffit plate, or it may be used in combination with the 2018S
soffit plate when it is necessary for the closer arm to clear a separate overhead door
holder.
Extra-clearance -- #2018S Offset Soffit Plate: For
use where the need for additional clearance prevents use of the standard soffit plate.
This plate mounts to the frame soffit to provide up to 1-1/2" (38 mm) of clearance
when a separate overhead door holder is used. Standard mounting requires a 2-5/8" (67
mm) wide frame soffit. It may also be used where unusually high frame stops or
weatherstripping prevent the use of other soffit plates.
Parallel Arm Closer:
Brackets for Hold-Open Arms
Parallel Hold-Open/Fusible-Link Hold-Open -- #1618H
Adapter Plate: This Adapter Plate is supplied standard with all parallel arm hold-open
and fusible-link hold-open closers. It can also be used to convert regular arm or top jamb
hold-open and fusible-link hold-open arms to parallel arm installation. It can be mounted
where the frame soffit is as narrow as 1" (25 mm).
Flush Transom Hold-Open -- #2020 Angle Bracket: For
use where rabbeted or flush transom conditions prevent installation of the standard 1618H
hold-open adapter plate. It can also be used to convert regular arm or top jamb hold-open
and fusible-link hold-open arms to parallel arm installation. |
