SERIES 8301/8501
ACCESSORIES
The following accessories are available for use with Series
8301/8501 door closers.
The accessories are divided into the basic groups of closer
mounting: Regular Arm, Top Jamb, Parallel Arm, and Parallel Rigid Arm. These groups
include Arm Brackets for Non-Hold-Open and Hold-Open installations; and Closer Mounting
Brackets and Plates.
The initial statement in each paragraph outlines the
situation for which the accessory is intended. Example:
Molded/Bull Nose Trim: You are attempting to mount a
Regular Arm, Non-Hold-Open closer on a frame with molded or bull nose trim. The convex
frame surface prevents use of the standard non-hold-open mounting shoe.
By referring to the descriptions that follow, the specifier
can determine that it would require a 2403 bracket to complete the installation.
Regular Arm Closers:
Brackets for Non-Hold-Open Arms
Molded/Bull Nose Trim -- #2403 Bracket: For use
where the door frame has molded or bull nose trim which will not accept a standard
non-hold-open shoe. The bracket is mortised into the frame rabbet, and projects beyond the
face of the frame. It will accommodate a frame rabbet up to 2" (51 mm) deep.
Molded/Bull Nose Trim -- #2403-3/4 Bracket:
This bracket is similar to -- but longer than -- the 2403 bracket, It is designed to
accommodate frame rabbets from 2" to 2-7/8" (51 mm to 73 mm) deep.
Regular Arm Closers:
Brackets for Hold-Open Arms
Molded/Bull Nose Trim -- #80 Bracket: For use where the
door frame has molded or bull nose trim which will not accept a standard hold-open shoe.
It is mortised into the frame rabbet, and projects beyond the face of the frame. It will
accommodate a rabbet up to 2" (51 mm) deep. This bracket is used in combination with
the standard hold-open mounting shoe.
Molded/Bull Nose Trim -- #80-3/4 Bracket: This
bracket is similar to -- but longer than -- the 80 bracket, and will accommodate frame
rabbets from 2" to 2-7/8" (51 mm to 73 mm) deep. This bracket is used in
combination with the standard hold-open mounting shoe. |
