Installation Using Beads

Installation Using Pats

General Information and Directions for the Use of Palmer QwikSet

Palmer QWIKSET™ MIRRO-MASTIC^® is a high-quality superior adhesive that possesses long-life resiliency due to its live strength, extra low shrinkage and faster set-up time. This permits trim and evenface finishing with mirror-to-mirror or mirror-to-glass overlays.

DIRECTIONS FOR SUBSTRUCTURE, MIRROR PREPARATION AND APPLICATION:

1.) Make sure both surfaces are free of dust, clean and dry. On nonporous substructures such as glass, tile or metal, priming or sealing is not necessary. If used on porous substructure, use a primer or sealer on dry, clean substructure and allow it to dry. Never apply primer, sealer or QwikSet to a painted surface or wall covering.

2.) Cut the tapered spout on the cartridge so it will dispense the desired size bead or pat of QwikSet.

3.) Apply sufficient QWIKSET so that when the mirror is pressed into place the adhesive will cover approximately 60% of the back of the mirror (see illustrations above). Leave an air space between the beads or pats to allow the adhesive to set up. After mastic application, press mirror into place allowing1/32" to 1/16" space between mirror and substrate. Care should be taken to make sure that QwikSet is not applied too heavy or close to the edge causing "squeeze out" that will have to be cleaned off. Any clean up should be done with mineral spirits.

4.) Support mirror at the bottom. This may be done with double-face tape tabs left in place, permanent L hangers, or "J" channel.

5.) For best adhesion both the mirror and the substrate should be above 40°F (4.4°C)

WARRANTY DISCLAIMER
Nothing herein shall be deemed to constitute a warranty, either express or implied by Palmer Products Corporation with respect to QWIKSET™ MIRRO-MASTIC^® . Palmer hereby disclaims all warranties, including without limitation, implied warranties of merchantability and fitness for a particular purpose. This disclaimer shall extend to all users of Palmer Products and to any third party. Any dispute or claim of whatsoever type arising out of the use of any Palmer Product shall be governed by the laws of the Commonwealth of Kentucky. Palmer’s sole liability, if any, and any user’s or third party claimant’s sole and exclusive remedy relating to any such dispute or claim shall be replacement of the Palmer product used.

CAUTION: FLAMMABLE
Vapors may ignite explosively; prevent build up of vapors. Open all windows and doors. Use only with cross ventilation. Do not smoke. Extinguish all flames and pilot lights and turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Close containers after use. Keep away from heat, sparks and open flame.

KEEP OUT OF REACH OF CHILDREN

PALMER PRODUCTS ALSO FEATURES A COMPLETE LINE OF MIRROR INSTALLATlON PRODUCTS INCLUDING; MIRRO-MASTIC, THE INDUSTRY LEADER FOR OVER 65 YEARS, MIRRO-BAC PAINT, MIRRO-MASTIC BOND AND SUPERSET MIRRO-MASTIC.

3m7/98v.3A