Latching Panic Exit Saddle Thresholds - Thermal Barrier
• A 1/8" wide key of black rigid vinyl between extrusions provides a thermal barrier (designated by 'FG' following the finish code).

Floor Closer Thresholds and Cover Plate Assemblies

• Fabrication does not affect handicap or fire labeling of assembly materials.
• When ordering, please provide the following information:
  TYPE OF ASSEMBLY - Type 11 or 14 for center hung, Type 13 or 15 for offset hung.
  MATERIALS - Saddles, floor plates, supports, risers, elevators, and stop strips. Minimum width is 7".
  NET LENGTH - Jamb to jamb. Assembly Types 11, 13, and 14 are cut with center section 1/2" over net length up to 48" and 1" over net length over 48" to allow for fitting on the job. Please specify "net length",if required. Assembly Type 15 is cut at net length because of factory cut miters.
  HANDING - For single doors, specify right or left hand. For pairs of doors, handing is not required.
  SPECIAL FINISHES - Examples include polished, chrome plate, oxidized & oil rubbed, and PemKote™.
  SPECIAL FASTENERS - (For center section only). Examples include MS & ES, FHSL25, and SS/MS & ES.
  SPECIAL FABRICATION INSTRUCTIONS - Notching, full miters, etc. Assembly Type 11 is supplied without mitered ends, and assembly Types 13, 14, and 15 are supplied with both ends mitered. Also, when ordering stop strips (184, 284, and 290), specify door thickness and pivot offset so that the threshold assembly width and pivot dimension can be determined.

Floor Plates, Supports and Safety Treads

• Furnished undrilled unless drilling instructions are specified with order. Ordering of fasteners does not constitute drilling instructions.

• Pemko can fabricate almost any floor plate threshold you might require.

• Extruded bronze (brass) plates are fluted on both sides.

PEMKO MFG. CO.  • VENTURA, CA (800) 283-9988 •MEMPHIS, TN (800) 824-3018