TECHNICAL DATA
| Weight of Solids |
29% |
| Volume of Solids |
20% |
| VOC |
less than 100 grams per liter |
| Specific Gravity |
1.16 |
| Density |
9.7 pounds per gallon |
| Flash Point |
None (C.O.C. method) |
| Gloss |
35 - 50/satin luster (A.S.T.M. Test D-523, 60° F) |
| pH |
8.5 ± 0.2 |
| Viscosity |
250 to 400 cps. (Brookfield RVF - 100, 50 rpm, spindle
3) |
| Abrasion Resistance |
Taber Abrasion, 500 cycles: Passes |
| Scrub Test (1000 revolutions) |
Passes |
| Drying Time |
To touch - 30 to 45 minutes at 68°, 50% relative
humidity
Recoat - 1 to 2 hours at 68°, 50% relative humidity |
| Form |
Opaque, white liquid |
| Odor |
Slight, sweet |
SURFACE PREPARATION
Surface must be at least 7 days old, dry, clean and completely free of oil, grease, loose
or chalking paint, dirt, etc. If necessary, clean with QC CONCRETE DEGREASER or QC FLOOR
CLEANER, rinse with clean water and allow to completely dry prior to application of QC
VERTICAL STAIN.
APPLICATION
QC VERTICAL STAIN may be applied by brush, roller, sponge, pump sprayer or airless
sprayer. Allow each coat to dry completely (approximately 1 to 2 hours) before applying
subsequent coats. The application of more than 3 coats of QC VERTICAL STAIN may result in
penetration and adhesion problems.
QC VERTICAL STAIN is warranted to be of uniform qualify within
manufacturing tolerances. Since control is not exercised over its use, no warranty
expressed or implied, is made as to the effects of such use. Seller’s and
manufacturer’s obligation under this warranty shall be limited to refunding the
purchase price of that portion of the material proven to be defective. QC Construction
Products, is a regestered trademark and servicemark with the U.S. patent office and other
foreign countries. QC Constuction Products, Madera, CA.
QC
Construction Products are available through: |
For ordering
information call
800-453-8213
 |
MADERA, CA |
www.qcconprod.com
2.5M1299
