| Notes Dimensions shown are for U.S. applications. For specific
requirements in Canada, please consult your local Canadian sales office.
(i) Maximum standard travel based on Cab
125 (8'-0" high), 4'-0" pit and across the line starting. Higher travel may be
available under some conditions. (Contact your local sales representative.)
(ii) SSSO doors available with right or
left opening.
(iii) Minimum pit depth is 4'-0".
Maximum travel will be decreased one inch for every inch of pit depth above 4'-0" .
For maximum pit depth on semi-holeless application, consult your local sales
representative
(iv) For travel greater then 9'-6",
jack hole may be required. Jack hole depth equals travel minus pit depth minus 54"
(minimum jack hold wherequired is 1'-6").
(v) Hoistway depth increases 1½"
with flush transoms.
(vi) Hoist Beam to be removed by othgers
after elevator installation if minimum cab clearance is not available.
(vii) For maximum rail bracket
vertial spacing consult your local sales representative.
(viii) Adequate steel or concrete
beam or concrete wall supports are required for rail mounting brackets based on elevator
shop drawing loadings at each floor per ASME A 17.1. Mounting and interface between
building support and rail bracket to be in agreement between customer and elevator
contractor.
(ix) Add 4" for less than 4000 lbs.
and 6" for 4000 lbs. and larger in seismic zone 2 or greater. |
