| Notes Dimensions shown are for U.S. applications. For specific
requirements in Canada, please consult your local Canadian sales office. When a custom cab
is applied, additional hoistway width may be required. Consult your local sales
representative.
(i) For front & rear openings,
maximum standard is limited to four openings front and four openings rear with maximum
total of our landings.
(ii) Maximum travel based on Cab 125
[8'-0" high (2439mm)], with overhead and pit dimensions as shown in the table.
(iii) SSSO and 2SSO doors available with
right or left opening.
(iv) Add 4" (102mm) for less than
4000 lbs. (1814 kg) and 6" (152) for 4000 lbs. (1814 kg) and larger in seismic zone 2
or greater.
(v) Hoist Beam to be removed by others
after elevator installation if minimum cab clearance is not available.
(vi) For maximum car and jack guide
rail bracket vertial spacing consult your local sales representative.
(vii) Adequate steel or concrete
beam or concrete wall supports are required for rail mounting brackets based on elevator
shop drawing loadings at each floor per ASME A 17.1. Mounting and interface between
building support and rail bracket to be in agreement between customer and elevator
contractor.
(viii) Left hand doors (not shown) have
opposite jack arrangement. |
