architecture - engineering - construction
Seachrome Corporation
Seachrome Products
Seachrome Grab Bars - Page 14
Seachrome Products
| GRAB BARS |
| 1 |
CW-Concealed Flange10 gauge - 1/2" Deep |
| 2 |
CW - Concealed Flange-BRIGHT BRASS 10 gauge - 1/2"
Deep |
| 3 |
CW - Concealed Flange - PEENED 10 gauge -1/2" Deep |
| 4 |
EE - Exposed Flange -8 gauge Countersunk Screw Holes |
| 5 |
EW- Exposed Flange -10 gauge |
| 6 |
CW- Concealed Flange - 10 gauge -1/2" Deep CENTER
SUPPORT |
| 7 |
325-2424 ANGLE BAR |
| 8 |
ER - Flange -14 gauge |
| 9 |
CR - "SNAP ON" Concealed Flange 14 gauge Flange,
20 gauge Snap On |
| Seachrome offers a complete line of grab
bars that meet all building codes for use where maximum safety, durability and reliability
are mandatory. All mounting flanges are heliarc welded to the bars to support loads in
excess of 420 pounds when properly installed. All bars are furnished with #10 x 2"
stainless screws. |
| Standard Finish is a polished 180 grit,
satin finish. Also available with polished brass or colored finishes or with peened or
knurled grip surfaces |
| Tubing
- |
18
gauge (0.049"), Type 304 Stainless Steel
"H" - 1-1/2" (38mm) O.D.
"Q" - 1-1/4" (32mm) O.D.
"S" - 1" (25mm) O.D. |
| Concealed Screw Flanges |
| 3" (76mm) Diameter; Type 304 Stainless Steel |
| "CR"
- |
14
gauge (1.9mm) base plate with 20 gauge (.9m) Snap-On Cover Three concealed screw holes |
| "CW"
- |
10
gauge (3.4mm) 1/2" Deep Flange, welded to bar, secured to a 14 gauge (1.9mm) wall
plate with 4 set screws. |
| Exposed Screw Flanged |
| 3" (76mm) Diameter; Type 304 Stainless Steel |
| "ER"
- |
14
gauge (1.9mm) - 3 screw holes |
| "EW"
- |
10
gauge (3.4) - 3 screw holes |
| "EE"
- |
8
gauge (4.2mm) - 3 countersunk screw holes |
RESIDENTIAL SAFETY BARS - SERIES 325 |
| These safety bars are
constructed of 7/8" O.D. x .035", highly polished Type 304 Stainless Steel Bars
held by heavy duty cast Zamac end posts which have been hand polished and plated with
heavy coats of copper, nickel and chrome, and secured by three #10 x 2" stainless
steel screws per post. Each safety bar meets the requirements of all Federal and State
specifications. Available in either straight or angled configurations. |
|
