SPECIFICATIONS
PART 1 - GENERAL
1.01 DESCRIPTION OF WORK
Extent of the canopies required is
shown on the drawings. Included
herein, but not limited to are decking,
fascia/gutter, columns, anchors,
supports, and flashing.
1.02 MEASUREMENTS
Verity all dimensions shown on
drawings by taking field measurements
to insure proper fit and attachment of
all component parts.
1.03 SUBMITTALS
Provide manufacturers shop drawings,
including fabrication and installation
details.
1.04 COORDINATION
Provide necessary anchors, blockouts,
flashing and other items required to be
built-in inample time to avoid delays
to the job.
1.05 DELIVERY& STORAGE
Deliver and store all items in
protected areas. Keep free of any
damage. Replace any damaged items
or parts at no cost to the Owner.
1.06 DESIGN PARAMETERS
Live load of the canopies shall be no
less than 20 p.s.f. Canopies shall
comply in all respects with
Southern Building Code Congress
international requirements for Floor,
Wall & Roof systems.
PART 2 - MATERIALS AND
PRODUCTS
2.01 ACCEPTABLE MANUFACTURER
Subject to compliance with requirements
herein, provide product manufactured by
Superior Metal Products Company,
Birmingham, Alabama.
2.02 PRODUCT AND MATERIALS:
(Consult Superior Metal Products'
Architect Manual and design staff for
detailed specifications of materials
and products.)
PART 3 - INSTALLATION AND
ERECTION 3.01
3.01 INSTALLATION
Canopies shall be installed according
to approved plans and shop drawings
and the entirestructure shall be erected
straight, true, and plumb in accordance
with standard construction procedures.
All joints and connections shall be tight
and clean, and all surfaces of work left
in a clean condition.
|
 |
_______________________________________________________
