StoneWear (Stonewear)

stone02a.gif (5002 bytes)

Typical Details

Here's what you do.

	Select fountain model. Fill out the on-line Quick Quote form including site information. Provide site improvements as specified by STONEWEAR.
1.	Level concrete slab (or similar) for fountain foundation.
2.	30" square excavated hole for utility stub outs located to bisect perimeter of fountain.
3.	Run water and drain plumbing from source at site to excavated hole. (Specified depth per local code)
4.	Run conduit and electric wires from site breaker panel to excavated hole.
5.	Breaker specified by STONEWEAR installed by licensed electrician.
6.	Install STONEWEAR timer controls and light transformer by licensed electrician.

Here's What we do

	Provide quotation including freight to fountain installation site. Provide complete fountain including:
7.	Basin, center feature, pump(s), lights, plumbing, control valves, and electrical circuits.
8.	Pre-plumbed fountain basin with valves for water input and drain plumbing to common site in fountain bottom.
9.	Fountain basin electrical reassembled with waterproof junction boxes to common site in the fountain bottom.
10.	Specify wire and conduit sizes.
11.	Provide GFI protected timer controls for pump(s), lights, and transformer.

Fountain Component Descriptions

PUMP(S): Submersible pump(s) installed inside fountain basin. certified.

LIGHTS: Sealed submersible lights with extra cord length to allow extraction from water to replace bulbs. 12 volt. UL listed.

CONTROLS: Two timers, 7-day/24 hour (pump and lights). NEMA 3 enclosure. GFI protection each component. UL listed.

WATER FEATURES: Adjustable flow to separate elements in water feature. Built-in chemical feeder using chlorine or bromine tablets.

PLUMBING: High level overflow drain. Manual main drain. Manual water fill. Automatic water level control. Feature control valves.

DOCUMENTATION: Operation manual. Illustrated installation instructions. Specific site plan specifications. Plumbing and electrical schematics. Component data sheets.

PLACEMENT/HOISTING: Easy to move with removable 'lifting eyes'.

CAST STONE: Proprietary compound of graded stone, cement, and alkaline-resistant glass fiber.

*Note: STONEWEAR reserves the right to change any specifications without notice.

Major Component Locations

Utility access panels

Valve to control each element in water feature.

All utilities connect in this area.

Utilities from site.

Make connections and fill hole.

Stainless steel threaded embed for pick up eye.

Proprietary STONEWEAR cast stone, typical.

Submersible pumps, typical.

Lights in niche mounts, typical

Concrete slab foundation. 1 : 2.5 : 5

NOTE: Timer controls located at site breaker panel.

stone06c.gif (9242 bytes)

What does this mean?
The Canadian Standards Association (CSA) has certified the product.
So what I live in Kansas. Under the CSA symbol you will notice the letters "NRTL/C". This indicate that the product was tested to meet U.S. standards as well as Canadian standards.

On December 24, 1992, CSA's Rexdale (Toronto) facility was officially accredited by the U.S. Occupational Safety and Health Administration (OSHA), as a Nationally Recognized Testing Laboratory (NRTL). The CSA's accreditation covers testing and certification to over 360 ANSI/UL Standards for a wide range of electrical, electronic and other products which require testing or certification by a NRTL, in accordance with OSHA regulations.

Click here to go to the STONEWEAR home page.

StoneWare - All it Takes is a Few Simple Steps