Design Guide - Page 8

600 SERIES PLANNING INFORMATION

Planning Information

Although the 600 Series offers a wide range of designs and configurations, the basic planning considerations for all models have much in common. As you integrate Sub-Zero units into your overall plan, review installation requirements for your particular units. Illustration 1 and the Pre-Installation Specifications chart provide planning information for all Sub-Zero 600 Series units – framed, overlay and stainless steel.

Allow units to open a minimum of 90 degrees or you’ll have problems removing drawers. With the door opening 90 degrees, you may have to move drawers slightly to clear the door interior. Refer to the minimum door clearances in the Pre-Installation Specifications chart.

• For corner installations, allow for a minimum two-inch filler so that the door can open to 90 degrees. If you’re using raised panels, consider using a wider filler.

• When units are installed side by side, use a filler strip. The width of this filler strip will vary depending on the configuration and panels you use.

• Be sure to add the filler strip width to your finished rough-in dimension. In any side by side installation, add an additional one-half inch to your combined numbers.

IMPORTANT NOTE: Refer to the full scale illustrations at the end of this section for specifics on door openings and filler size alternatives.

Pre-Installation Specifications