|
|
Sub-Zero
Design Guide
Design Guide - Page 9
Design Guide
 600 SERIES PLANNING INFORMATION
Integrating Cabinetry In your plan for panels, be sure you are working with the Sub-Zero panel design family called for in your design. If your customer has chosen the stainless steel design, the unit will be shipped complete with wrapped stainless steel doors and handle hardware. You will not have to install panels.If you and your client have ordered either framed or overlay design models, you will be adding panels to give the unit the custom Sub-Zero look. Be sure to keep the following details in mind. Framed PanelsIf the thickness of the custom panels is less than 1/4-inch, they must be backed up with a sheet of shim material to build the total thickness to 1/4-inch. If the panel is thicker than 1/4-inch, an edge must be routed around the panel to get a proper fit. See illustrations 3 and 4. IMPORTANT NOTE: On all models except Model 690, routing, recessing or optional extended handles may be required on raised panels for finger clearance under the handle. Refer to the full scale illustrations at the end of this section. To install framed panels, see the detailed procedures outlined in the Sub-Zero 600 Series Installation Guide. IMPORTANT NOTE: The weight of each panel cannot exceed 50 pounds.
Framed Panel Specifications
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
