Close Spacing Of Chiller

The air-cooled Series R® chiller has the tightest recommended side clearance in the industry, four feet, but that is not all. In situations where equipment must be installed with less clearance than recommended, such as frequently occurs in retrofit and rooftop applications, restricted air flow is common. Conventional chillers may not work at all. However, the air-cooled Series R chiller with Adaptive Control™ microprocessor will simply make as much chilled water as it can given the actual installed conditions, stay on line during any unforeseen abnormal conditions, and optimize its performance. Consult your Trane sales engineer for more details.

Lower Service Expense

Nuisance service calls are avoided. When there is a real problem that must be corrected, the UCM’S extensive diagnostics help assure that the problem is quickly identified. Down time and service expense are minimized. And with the ability to communicate with the Trane Integrated Comfort™ system or a remote display panel, service problems can be identified and diagnosed remote to the installation.

Factory Testing Means Trouble-Free Start-Up

All air-cooled Series R chillers are given a complete functional test at the factory. This computer-based test program completely checks the sensors, wiring, electrical components, microprocessor function, communication capability, expansion valve performance and fans. In addition, each compressor is run tested with refrigerant to verify capacity and power consumption. Where applicable, each unit is factory preset to the customer’s design conditions, including leaving water temperature setpoint, current limit, and reset temperature setpoint. The end result of this test program is that the chiller arrives at the jobsite fully tested and ready to go to work

Factory Installed And Tested Controls/Options Speed Installation

All Series R chiller options, including control power transformer, starter disconnect, low ambient control, ambient temperature sensor, low ambient lockout, communication interface and ice making controls are factory installed and tested. Some manufacturers send options in pieces to be field installed. With Trane, the customer saves on installation expense and has assurance that ALL chiller controls/options have been tested and will function as expected.